Hard drive
NOTE: The hard drive spare part kit does not include the hard drive bracket, hard drive connector cable, or screws. These components are included in the Hard Drive Hardware Kit, spare part number
Description | Spare part number |
|
|
|
|
|
|
Before removing the hard drive, follow these steps:
1.Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.
2.Disconnect the power from the computer by unplugging the power cord from the computer.
3.Disconnect all external devices from the computer.
4.Remove the bottom cover (see Bottom cover on page 33).
5.Disconnect the battery cable from the system board (see Battery on page 35).
Remove the hard drive:
1.Disconnect the hard drive cable (1) from the system board.
2.Remove the three Phillips PM2.5×5.5 screws (2) that secure the hard drive to the top cover.
Component replacement procedures | 43 |