Power connector cable
Description | Spare part number |
|
|
Power connector cable (includes bracket) | |
|
|
Before removing the power connector cable, follow these steps:
1.Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.
2.Disconnect the power from the computer by unplugging the power cord from the computer.
3.Disconnect all external devices from the computer.
4.Remove the bottom cover (see Bottom cover on page 33).
5.Disconnect the battery cable from the system board (see Battery on page 35).
Remove the power connector cable:
1.Disconnect the power cable (1) from the system board.
2.Release the power cable from the clips (2) and the routing channel built into the top cover.
3.Remove the two Phillips PM2.0×4.5 screws (3) that secure the power connector and bracket to the top cover.
4.Remove the power connector bracket (4).
Component replacement procedures | 57 |