HP manual HP Jetdirect 640n Print Server

The HP Jetdirect 640n Print Server

The HP Jetdirect 640n Print Server provides a single RJ-45 connector port for a network connection using an unshielded, twisted-pair network cable. It also contains a high-speed USB connector on the front panel.

Figure 1-1HP Jetdirect 640n Print Server

The HP Jetdirect 640n Print Server supports connection to IEEE 802.3 10Base-T, IEEE 802.3u 100Base-TX Fast Ethernet and 802.3ab 1000Base-T Gigabit Ethernet compliant networks. When connected and powered on, the print server auto-negotiates with your network to operate with a link speed of either 10, 100, or 1000 Mbps, and to communicate using full- or half-duplex mode. However, you can manually configure the link using the printer control panel, or through other configuration tools once network communications is established.

The HP Jetdirect 640n Print Server can support multiple network protocols simultaneously, including TCP/IPv4, TCP/IPv6, IPX/SPX, AppleTalk (EtherTalk), and DLC/LLC. For security, the print server includes features to control IP traffic to and from the device and supports configuration of IP Security (IPsec) protocols.

NOTE: By factory default, only TCP/IP is enabled; other network protocols are disabled.

For other available HP Jetdirect print server products, visit http://www.hp.com/go/jetdirect.

Using the HP Jetdirect print server, setting up your network printer is easy:

●Install the HP Jetdirect 640n Print Server hardware and connect the printer to your network.

●Use HP network installation software to configure the print server for network communications, and to add the printer on each computer system that will send print jobs directly to the printer.

For detailed instructions, see Install the HP Jetdirect 640n Print Server on page 7.

2 Chapter 1 Introduction ENWW