HP 640n Print Server Configure Keys Transmit Key, Entry Method, Key 1 through, Reset, Enable

Table A-1HP Jetdirect EIO Menu on Graphical Control Panel (continued)

Menu item	Sub-menu item	Sub-menu item	Values and Description
	Configure Keys	Transmit Key	Displays if WEP selected.
		Entry Method	Format for WEP key entry.
			Auto: Automatically generate a valid WEP key.
			Alphanumeric: Alphanumeric ASCII characters (0–9,
			a–z, A–Z). For 40/64-bit encryption, enter 5
			characters. For 104/128-bit encryption, enter 13
			characters. ASCII entries are case-sensitive.
			HEX: Hexadecimal digits (0–9, a–f, A–F). For 40/64-
			bit encryption, enter10 hexadecimal digits. For
			104/128-bit encryption, enter 26 hexadecimal digits.
			HEX entries are not case-sensitive.
		Key (1 through 4)	The print server can store up to four WEP keys using
			four key positions (Key 1, 2, 3, 4). To enter a WEP
			key, specify the key position followed by the
			encryption key value.
		Reset 802.11	Reset the wireless 802.11 settings to their default
			values (Yes or No).
TCP/IP	Enable		Off: Disable the TCP/IP protocol.
			On (default): Enable the TCP/IP protocol.
	Host Name		An alphanumeric string, up to 32 characters, used to
			identify the device. This name is listed on the
			HP Jetdirect configuration page. The default host
			name is NPIxxxxxx, where xxxxxx is the last six digits
			of the LAN hardware (MAC) address.
	IPV4 Settings	Config Method	Specifies the method that TCP/IPv4 parameters will
			be configured on the HP Jetdirect print server.
			Bootp: Use BootP (Bootstrap Protocol) for automatic
			configuration from a BootP server.
			DHCP (default): Use DHCP (Dynamic Host
			Configuration Protocol) for automatic configuration
			from a DHCPv4 server. If selected and a DHCP lease
			exists, DHCP Release and DHCP Renew menus are
			available to set DHCP lease options.
			Auto IP: Use automatic link-local IPv4 addressing. An
			address in the form 169.254.x.x is assigned
			automatically.
			Manual: Use the Manual Settings menu to configure
			TCP/IPv4 parameters.
		DHCP Release	This menu appears if Config Method was set to
			DHCP and a DHCP lease for the print server exists.
			No (default): The current DHCP lease is saved.
			Yes: The current DHCP lease and the leased IP
			address are released.

ENWW HP Jetdirect Menus for Graphical Control Panels 23