Connect the HP Jetdirect 2700w USB Solution Print Server
Use this section to connect the HP Jetdirect 2700w USB Solution Print Server.
CAUTION: HP Jetdirect print servers contain electronic components that can be damaged by static electricity through electrostatic discharge (ESD). To prevent ESD damage, maintain frequent contact with any bare sheet metal surface on the printer. A grounding wrist strap (or similar device) is useful for this purpose. Avoid touching electronic components or circuit paths.
1.Ensure that you have the latest firmware installed on the HP Jetdirect 640n Print Server and on the printer/MFP. (See the printer/MFP's setup or user guide for firmware upgrade instructions.)
2.Turn off the device, and disconnect the power.
3.Plug the USB connector on the HP Jetdirect 2700w USB Solution Print Server into the USB connector on the HP Jetdirect 640n Print Server. Tighten the thumb screws and ensure that the HP Jetdirect 2700w USB Solution Print Server is held securely in place.
+ =
4.Reconnect the power and turn on the device.
NOTE: When the power is restored, the HP Jetdirect 695n Print Server is in wireless configuration mode. Wireless network access is disabled until the configuration settings are completed. See Configure the HP Jetdirect 695n Print Server using the HP Embedded Web Server on page 15
14 Chapter 3 Create the HP Jetdirect 695n Print Server (connect the HP Jetdirect 2700w) | ENWW |