HP 640n Print Server manual Dhcp Renew, Manual Settings, Default IP, Primary DNS, Secondary DNS

Table A-1HP Jetdirect EIO Menu on Graphical Control Panel (continued)

Menu item	Sub-menu item	Sub-menu item	Values and Description
		DHCP Renew	This menu appears if Config Method was set to
			DHCP and a DHCP lease for the print server exists.
			No (default): The print server does not request to
			renew the DHCP lease.
			Yes: The print server requests to renew the current
			DHCP lease.
		Manual Settings	(Available only if Config Method is set to Manual)
			Configure parameters directly from the printer control
			panel:
			IP Address: The unique IP address of the printer
			(n.n.n.n).
			Subnet Mask: The subnet mask for the printer
			(n.n.n.n).
			Syslog Server: The IP address of the syslog server
			(n.n.n.n) used to receive and log syslog messages.
			Default Gateway: The IP address (n.n.n.n) of the
			gateway or router used for communications with
			other networks.
			Idle Timeout: The time period, in seconds, after which
			an idle TCP print data connection is closed (default is
			270 seconds, 0 disables the timeout).
		Default IP	Specify the IP address to default to when the print
			server is unable to obtain an IP address from the
			network during a forced TCP/IP reconfiguration (for
			example, when manually configured to use BootP or
			DHCP).
			Auto IP: A link-local IP address 169.254.x.x is set.
			Legacy: The address 192.0.0.192 is set, consistent
			with older HP Jetdirect devices.
		Primary DNS	Specify the IP address (n.n.n.n) of a Primary DNS
			Server.
			NOTE: This item appears only if Manual
			configuration is a higher priority than DHCP in the
			Config. Precedence table, configured through the
			embedded Web server.
		Secondary DNS	Specify the IP address (n.n.n.n) of a Secondary
			Domain Name System (DNS) Server.
			NOTE: This item will appear only if Manual
			configuration is a higher priority than DHCP in the
			Config. Precedence table, configured through the
			embedded Web server.
	IPV6 Settings	Enable	Use this item to enable or disable IPv6 operation on
			the print server.
			Off: IPv6 is disabled.
			On (default): IPv6 is enabled.

24 Appendix A HP Jetdirect EIO Control Panel Menus ENWW