SmartShare® User Manual
LED Indicators
The two LEDs for each LAN/WAN/Ext1/Ext2 Ethernet port indicate as follows:
LINK/ACT = Off | No connection. |
LINK/ACT = On, 10/100 = Off | 10Mbit link to other device established. |
LINK/ACT = On, 10/100 = On | 100Mbit link to other device established. |
LINK/ACT = Blink | Link is active with transmissions. |
The POWER LED indicates as follows: | |
POWER = Off | Power is off. |
POWER = Orange Light | Power is on. |
The STATUS LED indicates as follows: | |
STATUS = Green Light | The SmartShare is booting. |
STATUS = Green Blink Slow | Data connection to ISP is established. |
| Download Limiter is ready. |
STATUS = Green Blink Fast | Data connection to ISP is established. |
| Download Limiter is active. |
STATUS = Red Blink Slow | Connection to ISP is down or not established yet. |
STATUS = Red Blink Fast | (Not used.) |
STATUS = Red Light | Internal System Error. |
STATUS = Red and Green | Internal System Error. |
Glossary
ATL | Anti Terror Logger (or Anti Terror Logging) |
DHCP | Dynamic Host Configuration Protocol |
DNS | Domain Name System |
DSCP | Differentiated Services Code Point |
FTP | File Transfer Protocol |
IP | Internet Protocol |
ISP | Internet Service Provider |
LAN | Local Area Network |
LED | Light Emitting Diode |
MTU | Maximum Transmission Unit |
NAT | Network Address Translation |
NAPT | Network Address and Port Translation |
NTP | Network Time Protocol |
QOS | Quality Of Service |
SMTP | Simple Mail Transfer Protocol |
SNMP | Simple Network Management Protocol |
SPI | Stateful Packet Inspection |
TOS | Type Of Service |
WAN | Wide Area Network |
– 19 –