HP hn200e manual Ethernet gateway front panel LEDs, LAN indicators, Reset button

Page 8

Ethernet gateway

Ethernet gateway front panel LEDs

Ethernet Gateway front panel

LAN 1 2 3 4 WAN

POWER

RESET

LAN indicators

Power	Green. The Power LED lights green when
	the Gateway is powered on. There is no
	ON/OFF switch; simply plug or unplug the
	power to turn Gateway on or off.

LAN	Green. If the LAN LED is continuously lit,
	the Gateway is successfully connected to
	the device plugged into that port (1, 2, 3,
	or 4). If the LED is flickering, the Gateway
	is actively sending or receiving data
	through that port.

WAN	Green. The WAN LED lights when a
	successful connection is made between the
	Gateway and the Internet through your
	broadband modem.

reset button

To refresh Gateway connections and attempt to fix routing problems, very briefly depress the Reset button with a paper clip.

If you have exhausted all troubleshooting options (see the troubleshooting section of this user’s guide) and continue to experience serious routing problems, depress the Reset button for about five seconds to clear all of the Gateway data and restore the factory default settings.

Warning: Resetting the Gateway may create conflicts between your PCs’ actual IP addresses and what the Gateway expects them to be. You may be forced to restart the entire system.

8

Image 8

Contents Ethernet gateway Acknowledgements and notices Contents Specifications Introduction Hp digital home networking ethernet gatewayGateway features Ethernet gateway ports Getting to know the Ethernet gatewayEthernet gateway rear panel Ethernet gateway front panel LEDs LAN indicatorsReset button Ethernet gateway front panel LEDs Ethernet gateway Gateway system tray application OverviewGateway System Tray icon yellow Status notification windows Connection to Gateway Lost Internet Connection Operational Accessing a menu choice Pop-up menuCheck for upgrade Internet speed meter Gateway control panel Save the current Gateway configuration Choose location for configuration backup file Restore a previous Gateway configuration Internet connection diagnosticInternet connection diagnostic start window Internet connection diagnostic report window Internet Connection Diagnostic Parameter Message Meaning Interpreting a failed report for any parameterGet current network status Exit Notify me when network events occurAbout HP Digital Home Networking Ethernet gateway Gateway control panel Accessing the gateway control panel Select Gateway control panel Password hint window Cancel button Gateway control panel screenApply button OK buttonPassword tab Click Change PasswordClick Change Password Hint Gateway control panel tabsInternet Access tab Application Access tabTo block specified computers from Internet access To block access to Internet applicationsTo add a new application to the list To enable hosting of Internet servicesApplication Hosting tab To remove an application from the list FAQ & Troubleshooting tabExpert Interface tab Remote Support tab Frequently asked questions FAQs Gateway general informationWhat is DMZ Hosting? How can I block corrupted FTP downloads?Installation and configuration options Where is the Gateway installed on the network?How many IP addresses can the Gateway support? How many ports can be simultaneously forwarded?Ethernet gateway How do I get Napster to work with the Gateway? Supported softwareDoes the Gateway support ICQ send files? Does the Gateway support IPsec? Supported features What are the advanced features of the Gateway?Is IPSec Pass-Through supported by the EtherFast Gateway? Does the Gateway support IPX or AppleTalk?Upgrade information How will I be notified of new Gateway firmware upgrades?Can’t browse through the Gateway TroubleshootingCan’t connect to the Gateway Can’t access my e-mail or the Internet Can’t obtain an IP address from my cable or DSL modemAdvanced administration Appendix the expert interfaceScreens and functions DhcpSetup Ethernet gateway Setup Password To change your passwordTo enable remote management To change remote management passwordStatus Status Dhcp Dhcp Clients Table Screen Log Help Advanced FiltersAdvanced Filters Screen Select Enable Forwarding Port forwardingClick Port Triggering To add a server using forwardingTo delete a server entry To view the current routing table To set up Dynamic RoutingDynamic routing Static routing To view current routing table To create a static route entryTo delete a static route entry Click Delete this EntryTo deactivate the DMZ Host DMZ hostTo activate the DMZ Host MAC address clone Advanced Ethernet gateway Specifications GeneralEnvironmental Glossary CSMA/CD Carrier Sense Multiple Access/Collision Detect Default gatewayDhcp Dynamic Host Configuration Protocol Client/server networkESS Extended Service Set Essid Extended Service Set IdentificationDNS Domain Name System DSL Digital Subscriber LineFhss Frequency Hopping Spread Spectrum FirewallFirmware FTP File Transfer ProtocolISP Internet Service provider MAC Media Access Control addressInternet IntranetNetwork Network adapterNetwork mask NIC Network Interface CardPptp Point-to-Point Tunneling Protocol Print serverProtocol Proxy serverSsid Service Set ID SwitchServer SPI stateful packet inspectionWEP Wired Equivalent Privacy TCP/IP Transmission Control Protocol/Internet ProtocolTftp Trivial File Transfer Protocol Token ring topologyEthernet gateway Index Ethernet gateway Regulatory notices Hewlett-packard companyEthernet gateway