HP 3C509B-TP manual Windows NT Workstation Version Requirements

3Connecting to a Windows NT Server 3.51 Windows NT Workstation Version 3.51

Windows NT

Workstation

Version 3.51

Requirements

•HP Vectra with Microsoft Windows NT Workstation 3.51 installed.

•3COM Etherlink 3C509-B ethernet card and drivers disk ver. 5.0. Driver Name: Elnk3.SYS Size: 27KB Date: 7/18/96

•Microsoft Windows NT Workstation 3.51 and Service Pack Media.

•Microsoft Windows NT Server 3.51 machine that supports Net BEUI, TCP/ IP, NWLink IPX/SPX, and NWLink NetBIOS transfer protocols.

Device Configuration

		Vectra VL8	Vectra VL7		Vectra VE7/VE8
I/O Base Address		210h	210h		300
Interrupt Request		10	10		10
	Level
•	Boot PROM			Disabled
•	Transceiver Type			Auto Select
•	Network Driver Optimization			Windows or OS/2 Client
•	Maximum Modem Speed			9600 Bps
• Plug and Play Compatibility				Disabled
•	Full Duplex			Disabled

Procedure

1With the HP Vectra turned off, install the 3COM Etherlink III 3C509-B adapter card into an ISA slot.

2Connect network cable media to the 3COM 3C509B card.

3Insert a DOS bootable diskette and power on the machine.

4After booting, insert the 3COM Software “3C509-B Ethernet drivers disk ver 5.0.” and execute “A:\3C5X9CFG.EXE.”

5Select “CONFIGURE NIC” and verify the resource settings listed above under the heading “Device Configuration.”

6If changes are required, save those changes and exit.

If you are using a Vectra VL8 or VL7, go directly to step 7.