HP 3C509B-TP manual Connecting to a Netware 4.11 Server

2 Connecting to a Netware 4.11 Server

Windows for Workgroups

Windows for Workgroups

2 Connecting to a Netware 4.11 Server

Requirements

•HP Vectra with DOS and MS-Windows for Workgroups 3.11 installed.

•3COM Etherlink 3C509-B ethernet card and drivers disk ver. 5.0. DOS ODI - File Name: 3C5X9.COM Size: 42KB Date: 7/21/96

•DOS and MS-Windows for Workgroups 3.11 media.

•Novell Netware server 4.11 that supports Net BEUI, NWLink IPX/SPX, and NWLink NetBIOS transfer protocols.

•Netware client for DOS and MS-Windows.

Device Configuration

•	I/O Base Address	300
•	Interrupt Request Level	10
•	Boot PROM	Disabled
•	Transceiver Type	Auto Select
•	Network Driver Optimization	Windows or OS/2 Client
•	Maximum Modem Speed	9600 Bps
• Plug and Play Compatibility		Disabled
•	Full Duplex	Disabled

Procedure

1With the HP Vectra turned off install the 3COM Etherlink III 3C509-B adapter card into an ISA slot.

2Power on the machine and allow it to boot to a DOS prompt.

3Insert the 3COM drivers diskette (ver. 5.0 downloaded from 3COM’s website) and execute 3C5X9CFG.EXE.

4Select “CONFIGURE NIC,” and verify the resource settings listed above under the heading “Device Configuration.”

5If changes are required, save those changes and exit.