HP 3C509B-TP manual Windows for Workgroups Ver

4.Connecting to a Windows NT Server 4.0 Windows for Workgroups Ver. 3.11

Windows for Workgroups Ver. 3.11

4. Connecting to a Windows NT Server 4.0

Requirements

•HP Vectra with DOS and MS-Windows for Workgroups 3.11 installed.

•3COM Etherlink 3C509-B ethernet card and drivers disk ver. 5.0. Driver Name: Elnk3.SYS Size: 27KB Date: 7/18/96

•Microsoft Windows NT Server 4.0 machine that supports Net BEUI, NWLink IPX/SPX, and NWLink NetBIOS transfer protocols.

Device Configuration

•	I/O Base Address	300h
•	Interrupt Request Level	10
•	Boot PROM	Disabled
•	Transceiver Type	Auto Select
•	Network Driver Optimization	Windows or OS/2 Client
•	Maximum Modem Speed	9600 Bps
• Plug and Play Compatibility		Disabled
•	Full Duplex	Disabled

Procedure

1With the HP Vectra turned off, install the 3COM Etherlink III 3C509-B adapter card into an ISA slot.

2Connect network Cable Media to the 3COM 3C509B card.

3After booting to DOS, insert the 3COM’s drivers disk “Etherlink 3C509-B Ethernet ver. 5.0.”, and execute “A:\3C5X9CFG.EXE.”

4Select “CONFIGURE NIC,” and verify the resource settings listed above under the heading “Device Configuration.”

5If changes are required, save those changes and exit.

6Remove the 3COM Drivers diskette and reboot the machine.