HP 3C509B-TP manual Vectra VL7

4 Connecting to a Windows NT Server 4.0

Windows NT Workstation 4.0

Windows NT

Workstation 4.0

Requirements

•HP Vectra with Windows NT Workstation 4.0 Service Pack 3.

•3COM Etherlink 3C509-B ethernet card and drivers disk ver 5.0. Driver Name: Elnk3.SYS Size: 27KB Date: 7/18/96

•Microsoft Windows NT Workstation 4.0 and service pack media.

(If you have a Hewlett-Packard pre-loaded HDD, the media is located at “C:\I386”)

•Microsoft Windows NT Server 4.0 machine that supports Net BEUI, TCP/ IP, NWLink IPX/SPX, and NWLink NetBIOS transfer protocols.

Device Configuration

		Vectra VL8	Vectra VL7		Vectra VE7/VE8
I/O Base Address		210	210		300
Interrupt Request		10	10		10
	Level
•	Boot PROM			Disabled
•	Transceiver Type			Auto Select
•	Network Driver Optimization			Windows or OS/2 Client
•	Maximum Modem Speed			9600 Baud
• Plug and Play Compatibility				Disabled
•	Full Duplex			Disabled

Procedure

1With the HP Vectra turned off, install the 3COM Etherlink III 3C509-B adapter card into an ISA slot.

2Connect network media to the 3COM 3C509B card.

3Insert a DOS bootable diskette and power on the machine.

4After booting, insert the 3COM Etherlink 3C509-B Ethernet card and drivers disk ver 5.0. and execute “A:\3C5X9CFG.EXE.”

5Select “CONFIGURE NIC”, and verify the resource settings listed above under the heading “Device Configuration.”