5. Operation
Startup
1.Switch all of the connected equipment on.
2.Plug the power cord into the projector and into a wall socket.
3.Turn on the wall socket switch (where fitted).
4.Press Power on the remote control or projector to start the unit. The Power button flashes during warm up, then turns on solid.
5.The projector searches the input ports for an input signal. A message on the
screen shows the ports being searched.
You can also press source on the projector or remote control to select your desired input signal. For more information, please refer to page 21.
If the frequency or resolution of the input signal exceeds the projector’s operating range, you will see the message “Out of Range” displayed on a blank screen.
20 5. Operation