HP vp6220, vp6210 manual Troubleshooting, Projector does not turn on, No picture, Blurred image

7. Troubleshooting

The projector does not turn on.

Cause	Remedy
	Plug the power cord into the AC inlet on the
There is no power from the power	projector, and plug the power cord into the
cord.	power outlet. If the power outlet has a switch,
	make sure that it is switched on.
Attempting to turn the projector on	Wait until the cooling down process has
again during the cooling process.	completed.

No picture

Cause	Remedy
The video source is not turned on.	Turn the video source on.
The projector is not correctly	Check that the signal cable is connected
connected to the input source device.	correctly.
The input signal has not been	Select the correct input signal with the source
correctly selected.	button on the projector or remote control.
The lens cap is still attached to the	Remove the lens cap.
lens.

Blurred image

Cause	Remedy
The projection lens is not correctly	Adjust the focus of the lens using the focus
focused.	ring.
The projector and the screen are not	Adjust the projection angle and direction as
aligned properly.	well as the height of the unit if necessary.
The lens cap is still attached to the	Remove the lens cap.
lens

Remote control does not work.

Cause	Remedy
The battery is out of power.	Replace the battery in the remote control with
	a new one.
There is an obstacle between the	Remove the obstacle.
remote control and the projector.
You are too far away from the	Stand within 6 meters (19.5 feet) of the
projector.	projector.
For a PC connection, the USB cable is	To use the page up and page down functions,
	connect the USB cable between the PC and
not connected.	projector.

7. Troubleshooting 35