Shutdown
1.Press the Power button on the projector or remote
control. The Power button flashes and the lamp shuts down, the fans continue to run for approximately 2 minutes to cool down the projector.
To protect the lamp, the projector will not respond to any commands during the cooling process.
2.Disconnect the power cord from the wall socket.
Do not unplug the power cord before the projector shutdown sequence is complete or during the
If the projector is not properly shut down, and you attempt to restart it soon after, the fans may run for a few minutes to cool down. Press Power again to start the projector after the fans stop.
Source Selection
To sequentially select input sources, press source on the projector con- trol panel or the remote control. It may take you a few seconds when the projector is searching for input signals. The selected source will be displayed at the bottom right of the screen for 3 seconds. For a quick search, you can also press the key repeatedly until your desired signal is displayed.
5. Operation | 21 |