4.Loosen the screw that holds the lamp to the projector. If the screw is not loosened com-
pletely, they could injure your fingers. It is strongly recommended that you use a mag-
5.Slide the latch to release the lamp.
6.Lift the handle so that it stands up. Use the handle to slowly pull the lamp out of the projector.
Pulling it too quickly may cause the lamp to break and scatter broken glass in the projector.
Do not place the lamp in locations where water might splash on it, children can reach it, or near flammable materials.
Do not insert your hands into the projector after the lamp is removed. If you touch the optical components inside, it could cause color unevenness and distortion of the projected images.
7.Insert a new lamp. Make sure the handle is fully locked and tighten the screw firmly. Slide the latch so it holds the lamp.
If the screw is loose, it could result in a malfunction.
Do not over tighten the screw.
8.
9. Plug in the projector and turn it on.
10.Unplug all input cables.
11.Reset the lamp counter. Do not reset if the lamp is not replaced as this could cause damage.
i.Press and hold the 
up button on the projector for 5 seconds to display the reset message.
ii.Press auto sync on the projector or on the remote control to reset the lamp hours to “0”.
iii.Wait about 5 seconds to let the message disappear.
6. Maintenance | 33 |