HP Book 900 manual Removing the Hard Disk Drive, Exchange Information

Keyboard-screw cover RAM board

Screw, M2.5×4mm (2)

Figure 2-3. Removing a RAM Board

Reassembly Notes

∙Insert the RAM board into the connector at about a 30° angle until it is fully inserted. Then press down at both sides until both latches snap closed.

∙Fold the keyboard back into place. Slip its front tabs into the slots, then snap the back edge into place.

∙Push the keyboard toward the back as you tighten the two screws. This helps engage the tab at the back-center of the keyboard.

Removing the Hard Disk Drive

(User-Replaceable)

Exchange Information

When returning a bad hard disk drive to HP, describe the symptoms on a piece of paper and attach it to the part—do not use tape.

Table 2-5. Hard Disk Drive Replacement Part Numbers

Description

Drive, hard disk (4.3GB, 9.5mm, IBM) *

Drive, hard disk (4.3GB, 8.45mm, Toshiba)

Drive, hard disk (6.0GB, 9.5mm, IBM) *

Drive, hard disk (6.4GB, 9.5mm, IBM) *

Drive, hard disk (12GB, 9.5mm, IBM) *

Part Number

0950-3409

0950-3410

0950-3710

0950-3442

0950-3711

Exchange

Part Number

F1711-69100

F1386-69102

F1711-69106

F1711-69101

F1660-69105

OmniBook

900B	900†
	∙
	∙
∙
	∙
∙

*These hard drives are the preferred drives at the time of publication. Drives shipped in units are subject to change without notice. For current information about preferred and approved drives for these products, see the latest version of service note HDD-01.

†Models called 900† in this manual have no marking in the serial number, whereas models called 900B have 900 B after the serial number.

Required Equipment

∙Small Phillips screwdriver.

2-6 Removal and Replacement HP OmniBook 900