HP Book 900 manual Replacing Small Parts User-Replaceable, Replacement Procedure

Replacing Small Parts

(User-Replaceable)

The following small parts are user-replaceable.

Part

Battery panel

Bumper, display (upper)

Cap, pointing stick

Cover, display screw (lower)

Cover, hinge

Table 2-6. Replacing Small Parts (User-Replaceable)

Replacement Procedure

Remove the battery, then twist the upper edge of the panel off the battery.

Insert a small flat-blade screwdriver under the bumper and pry it loose. To replace, firmly press the adhesive side of the bumper into the recess.

Pull the cap off the pointing stick.

Insert a small flat-blade screwdriver under the cover and pry it loose. To replace, firmly press the adhesive side of the cover into the recess.

Put your finger above the F8 key and slide the keyboard-screw cover to the left about 3 mm (1/8 inch)—then lift off the cover. Open the display fully. Push in at the bottom- front of the cover to unsnap it from the top case.

Cover, keyboard screw

Door, hard disk

Foot

Put your finger above the F8 key and slide the keyboard-screw cover to the left about 3 mm (1/8 inch)—then lift off the cover.

Open the door about 45° and flex the door until one side tab releases.

Insert a small flat-blade screwdriver under the foot and pry it loose. To replace, firmly press the adhesive side of the foot into the recess.

HP OmniBook 900 Removal and Replacement 2-9