Toshiba RAV-SP180AT2-UL installation manual „ For Reference, Installation Manual

Page 12

Outdoor Unit

3)Place unit on stand. Make sure it is level and fasten securely to the stand.

•As shown in the figure below, install the foundation and vibration-proof rubber pads to directly support the bottom surface of the fixing leg that is in contact with the bottom plate of the outdoor unit.

•When installing the foundation for an outdoor unit with downward piping, consider the piping work.

GOOD

Mounting leg

Foundation

GOOD

Bottom plate

of outdoor unit

Foundation

Support the bottom surface of the mounting leg that is in contact with and underneath the bottom plate of the outdoor unit.

Installation Manual

Drain nipple

Waterproof rubber cap

(2pcs.)

Waterproof rubber cap

Base plate

Drain nipple

„For Reference

If a heating operation is to be continuously performed for a long time under the condition that the outdoor temperature is 32 °F (0 °C) or lower, draining defrosted water may be difficult due to the bottom plate freezing, resulting in trouble with the cabinet or fan.

If only the end of the mounting leg is supported, it may deform.

Foundation

NO GOOD

 

Do not support

 

the outdoor unit

 

 

 

only with the

 

 

 

mounting leg.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

•When water is to be drained through the drain hose, attach the following drain nipple and waterproof rubber cap, and use the drain hose (Inner diameter: 0.6” (16 mm)) sold on the market. Also seal the screws securely with silicone material, etc., to prevent water from leaking.

Some conditions may cause condensation or dripping of water.

•When collectively draining discharged water completely, use a drain pan.

11-EN

– 11 –

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Installation manual Contents Dimension Ø0.26 holeAccessory Parts System Requirements „ Piping Field suppliedPrecautions for Safety Be sure to ground the equipmentEquipment Damage Hazard Installation of NEW Refrigerant AIR Conditioner „ Required Tools/Equipment and Precautions for UseNew Refrigerant Air Conditioner Installation „ Installation Location Do not install the outdoor unit in the following locationExample „Required Clearances Unit in mmBarrier at rear side Barrier in front Upper side is free Above unit is free„ Installation of Outdoor Unit Standard installationBarriers in front and back of unit Installation Manual „ For ReferenceRefrigerant Piping „ Tightening of Flare ConnectionsFlaring Projection margin in flaring B Unit in mm Rigid Clutch typeDo not apply refrigerant oil to the flared surface „ Field wiring „ WiringElectrical Connections Using Vacuum Pump Evacuate and Dehydrate the SystemDeep Vacuum Method Triple Evacuation MethodOpen service valves Valve handling precautionsFinal Tubing Check Liquid and gas side11PERIODIC Maintenance Finishing10TEST RUN 13POWER Save Procedure12UNIT Pump Down EH99865301

RAV-SP180AT2-UL specifications

The Toshiba RAV-SP180AT2-UL is an innovative ducted air conditioning unit designed to deliver exceptional cooling and heating capabilities for both residential and commercial applications. Known for its efficiency and performance, this model integrates advanced technology that ensures optimal indoor climate control.

One of the primary features of the RAV-SP180AT2-UL is its energy efficiency. It operates with a high Energy Efficiency Ratio (EER) and Seasonal Energy Efficiency Ratio (SEER) ratings, allowing it to consume less electricity while providing maximum comfort. This efficiency not only contributes to lowering energy bills but also promotes environmentally friendly practices by reducing carbon emissions.

The air conditioning unit is equipped with Toshiba’s advanced inverter technology. This technology allows for precise temperature control and significant energy savings by continuously adjusting the compressor speed based on the desired temperature. With this capability, the system can operate quietly and maintain a stable climate, avoiding the sharp temperature fluctuations characteristic of traditional fixed-speed units.

Another significant feature of the RAV-SP180AT2-UL is its compact design, making it suitable for installation in various settings, including small apartments and larger commercial spaces. Its ducted system enables seamless air distribution, reducing visible components and maintaining the aesthetic of the interior space.

The unit also incorporates innovative filtration systems that improve indoor air quality. With advanced air purifying filters, it effectively minimizes allergens, dust, and pollutants, ensuring that the air circulated in the space is clean and healthy.

In terms of control, the RAV-SP180AT2-UL is compatible with a range of smart control options. Users can manage settings remotely via applications or programmable timers, allowing for convenience and the possibility of scheduling cooling and heating cycles according to personal routines.

Overall, the Toshiba RAV-SP180AT2-UL combines efficiency, compact design, and advanced technology, making it a strong contender in the ducted air conditioning market. Its ability to provide comfortable air conditioning solutions while being mindful of energy consumption is a testament to Toshiba's commitment to innovation in climate control technology.
Top Page Image Contents