Toshiba RAV-SP180AT2-UL installation manual „ Installation Location, Example

Page 9

Outdoor Unit

„Installation Location

WARNING

Install the outdoor unit in a location that can support the weight of the outdoor unit.

Insufficient durability may cause the outdoor unit to fall, which may result in injury.

Installation Manual

When an outdoor unit is installed in a location that is always exposed to strong winds like a coast or on the high stories of a building, one of the following is recommended.

Install the unit so that its discharge faces the wall of the structure.

Keep a distance 19.7” (500 mm) or more between the unit and wall.

19.7" (500 mm)

CAUTION

Do not install the outdoor unit in a location that is subject to combustible gas leaks.

Accumulation of combustible gas around the outdoor unit may cause a fire.

Install the outdoor unit in a location that meets the following conditions.

A well-ventilated location free from obstacles near the air inlets and air outlet

A location that does not increase the operating noise or vibration of the outdoor unit

A location that does not produce any drainage problems from discharged water

Location with easy access to power.

Do not install the outdoor unit in the following location.

A location with a saline atmosphere (coastal area) or one that is full of sulfide gas (hot-spring area) (Special maintenance is required.)

A location subject to oil, vapor, oily smoke, or corrosive gases

A location in which organic solvent is used

A location where high-frequency equipment (including inverter equipment, private power generator, medical equipment, and communication equipment) is used (Installation in such a location may cause malfunction of the air conditioner, abnormal control or problems due to noise from such equipment.)

A location in which the discharged air of the outdoor unit blows against the window of a neighboring house

A location where the operating noise of the outdoor unit is transmitted

When the outdoor unit is installed in an elevated position, be sure to secure its feet.

A location in which drain water poses any problems.

Install the unit so that the discharge is at a right angle relative to the wind direction.

Strong wind

Strong wind

Use wind baffle. Produce those parts in the field.

When outside temperature conditions are 23 °F (-5 °C) or lower and unit is running in cooling mode.

<Example>

Wind baffle

Wind baffle

EN

– 8 –

8-EN

Image 9
Contents Installation manual Contents Ø0.26 hole DimensionAccessory Parts „ Piping Field supplied System RequirementsBe sure to ground the equipment Precautions for SafetyEquipment Damage Hazard Installation of NEW Refrigerant AIR Conditioner „ Required Tools/Equipment and Precautions for UseNew Refrigerant Air Conditioner Installation „ Installation Location Do not install the outdoor unit in the following locationExample Unit in mm „Required ClearancesBarrier at rear side Barrier in front Upper side is free Above unit is free„ Installation of Outdoor Unit Standard installationBarriers in front and back of unit „ For Reference Installation Manual„ Tightening of Flare Connections Refrigerant PipingFlaring Projection margin in flaring B Unit in mm Rigid Clutch typeDo not apply refrigerant oil to the flared surface „ Field wiring „ WiringElectrical Connections Evacuate and Dehydrate the System Using Vacuum PumpDeep Vacuum Method Triple Evacuation MethodValve handling precautions Open service valvesFinal Tubing Check Liquid and gas side11PERIODIC Maintenance Finishing10TEST RUN 13POWER Save Procedure12UNIT Pump Down EH99865301

RAV-SP180AT2-UL specifications

The Toshiba RAV-SP180AT2-UL is an innovative ducted air conditioning unit designed to deliver exceptional cooling and heating capabilities for both residential and commercial applications. Known for its efficiency and performance, this model integrates advanced technology that ensures optimal indoor climate control.

One of the primary features of the RAV-SP180AT2-UL is its energy efficiency. It operates with a high Energy Efficiency Ratio (EER) and Seasonal Energy Efficiency Ratio (SEER) ratings, allowing it to consume less electricity while providing maximum comfort. This efficiency not only contributes to lowering energy bills but also promotes environmentally friendly practices by reducing carbon emissions.

The air conditioning unit is equipped with Toshiba’s advanced inverter technology. This technology allows for precise temperature control and significant energy savings by continuously adjusting the compressor speed based on the desired temperature. With this capability, the system can operate quietly and maintain a stable climate, avoiding the sharp temperature fluctuations characteristic of traditional fixed-speed units.

Another significant feature of the RAV-SP180AT2-UL is its compact design, making it suitable for installation in various settings, including small apartments and larger commercial spaces. Its ducted system enables seamless air distribution, reducing visible components and maintaining the aesthetic of the interior space.

The unit also incorporates innovative filtration systems that improve indoor air quality. With advanced air purifying filters, it effectively minimizes allergens, dust, and pollutants, ensuring that the air circulated in the space is clean and healthy.

In terms of control, the RAV-SP180AT2-UL is compatible with a range of smart control options. Users can manage settings remotely via applications or programmable timers, allowing for convenience and the possibility of scheduling cooling and heating cycles according to personal routines.

Overall, the Toshiba RAV-SP180AT2-UL combines efficiency, compact design, and advanced technology, making it a strong contender in the ducted air conditioning market. Its ability to provide comfortable air conditioning solutions while being mindful of energy consumption is a testament to Toshiba's commitment to innovation in climate control technology.