Troubleshooting
Problem | Possible Cause | Solution |
|
|
|
Image is not | Position may need | Press the Menu button to |
centered. | adjustment. | access the OSD Menu. |
|
| Select Image Control/ |
|
| Horizontal Position or |
|
| Vertical Position to adjust |
|
| the horizontal or vertical |
|
| position of the image. |
|
|
|
“No Connection, | Monitor video cable is | Connect the |
Check Signal Cable” | disconnected. | video cable to the VGA |
is displayed on |
| connector on the computer, |
screen. |
| or connect the |
|
| cable to the DVI connector |
|
| on the computer. Be sure |
|
| that the computer power is |
|
| off while connecting the |
|
| video cable. |
“Out of Range. Set Monitor to 1280 x 1024 @ 60Hz” is displayed on screen.
Video resolution and/or refresh rate are set higher than what your monitor supports.
Restart your computer and enter Safe Mode. Change your settings to a supported setting (see the table in “Preset Video Modes” in Appendix B). Restart your computer so that the new settings take effect.
User’s Guide |