York D2EB installation instructions Installation Instruction, General, Reference, Inspection

Page 1
CHAMPION® SERIES

J￿

 

CHAMPION® SERIES

 

 

 

SINGLE PACKAGE AIR CONDITIONERS

 

ELECTRIC/ELECTRIC, AIR-COOLED

INSTALLATION INSTRUCTION

Supersedes: Nothing

174065-YIM-A-0206

MODELS D2EB018 THRU 060

1-1/2 THRU 5 TON

(8.8 - 9.4 EER)

EXPORT

GENERAL

Model D2EB units are factory assembled cooling only air condi- tioners designed for outdoor installation on a rooftop or a slab. Field-installed electric heater accessories are available to provide electric heat combined with electric cooling. All units and heaters are certified by CSA.

The units are completely assembled on rigid, but easily remov- able base rails. All piping, refrigerant charge, and electrical wir- ing is factory installed and tested. The units require only electric power and duct connections at the point of installation.

The electric heaters have nickel-chrome resistance wire ele- ments and utilize single point power connection.

damage should be noted on the carrier's freight bill. A separate request for inspection by the carrier's agent should be made in writing. Refer to Form 50.15-NM for additional information.

REFERENCE

Additional information on the design, installation, operation and service of this equipment is available in the following refer- ence forms:

174065 -General Installation

511.26-N1.1V -Electric Heater Accessory

INSPECTION

As soon as a unit is received, it should be inspected for possible damage during transit. If damage is evident, the extent of the

REPLACEMENT PARTS

Refer to Replacement Parts Manual for complete listing of replacement parts on this equipment.

Installer should pay particular attention to the words: NOTE, CAUTION and WARNING. Notes are intended to clarify or make the installation easier. Cautions are given to prevent equipment damage. Warnings are given to alert installer that personal injury and/or equipment damage may result if installation procedure is not handled properly.

CAUTION

THIS PRODUCT MUST BE INSTALLED IN STRICT COMPLIANCE WITH

THE ENCLOSED INSTALLATION INSTRUCTIONS AND ANY APPLICABLE

LOCAL, STATE, AND NATIONAL CODES INCLUDING, BUT NOT LIMITED

TO, BUILDING, ELECTRICAL, AND MECHANICAL CODES.

WARNING

INCORRECT INSTALLATION MAY CREATE A CONDITION WHERE THE OPERATION OF THE PRODUCT COULD CAUSE PERSONAL INJURY OR PROPERTY DAMAGE.

Image 1
Contents REPLACEMENT PARTS INSTALLATION INSTRUCTIONGENERAL REFERENCELIMITATIONS INSTALLATIONTABLE 1 - UNIT APPLICATION DATA LOCATIONCLEARANCES SERVICE ACCESSDUCT WORK FILTERSFIG. 2 - TYPICAL FIELD WIRING DIAGRAM POWER AND CONTROL WIRINGCONTROL WIRING POWER WIRINGTABLE 4 - ELECTRICAL DATA BASIC UNIT TABLE 5 - ELECTRICAL DATA COOLING / ELECTRIC HEAT DEB Coil Delta P vs Airflow Checking Supply Air CFM174065-YIM-A-0206 174065-YIM-A-0206 FRONT FIG. 3 - DIMENSIONS AND CLEARANCESFRONT 14 BACKCooling SEQUENCE OF OPERATIONHeating NORMAL MAINTENANCE MAINTENANCESEE DETAIL B DETAIL ATYPICAL WIRING DIAGRAM NOTES TYPICAL WIRING DIAGRAM LEGEND174065-YIM-A-0206 Unitary Products GroupUnitary Products Group 174065-YIM-A-02065005 York Drive, Norman Oklahoma Unitary Products GroupSupersedes Nothing 174065-YIM-A-0206