York D2EB installation instructions Normal Maintenance

Page 12
MAINTENANCE

174065-YIM-A-0206

SECURE OWNER'S APPROVAL: When the system is functioning properly, secure the owner's approval. Show him the location of all disconnect switches and the thermostat. Teach him how to start and stop the unit and how to adjust temperature settings within the limitations of the system.

MAINTENANCE

NORMAL MAINTENANCE

WARNING: Prior to any of the following maintenance proce- dures, shut off all power to the unit, to avoid per- sonal injury.

Periodic maintenance consists of changing or cleaning filters and general cleaning of the outdoor coil.

FILTERS - Inspect once a month. Replace Disposable or clean Permanent Type as necessary. DO NOT replace Permanent Type with Disposable.

MOTORS - Indoor and outdoor fan motors are permanently lu- bricated and require no maintenance.

OUTDOOR COIL - Dirt should not be allowed to accumulate on the outdoor coil surface or other parts in the air circuit. Cleaning should be as often as necessary to keep the coil clean. Use a brush, vacuum cleaner attachment, or other suitable means. If water is used to clean the coil, be sure that the power to the unit is shut off prior to cleaning.

CAUTION: Exercise care when cleaning the coil so that the coil fins are not damaged.

Do not permit the hot condenser air discharge to be obstructed by overhanging structures or shrubs.

12

Unitary Products Group

Image 12
Contents INSTALLATION INSTRUCTION REPLACEMENT PARTSGENERAL REFERENCEINSTALLATION LIMITATIONSTABLE 1 - UNIT APPLICATION DATA LOCATIONSERVICE ACCESS CLEARANCESDUCT WORK FILTERSPOWER AND CONTROL WIRING FIG. 2 - TYPICAL FIELD WIRING DIAGRAMCONTROL WIRING POWER WIRINGTABLE 4 - ELECTRICAL DATA BASIC UNIT TABLE 5 - ELECTRICAL DATA COOLING / ELECTRIC HEAT Checking Supply Air CFM DEB Coil Delta P vs Airflow174065-YIM-A-0206 174065-YIM-A-0206 FIG. 3 - DIMENSIONS AND CLEARANCES FRONTFRONT 14 BACKSEQUENCE OF OPERATION CoolingHeating MAINTENANCE NORMAL MAINTENANCEDETAIL A SEE DETAIL BTYPICAL WIRING DIAGRAM LEGEND TYPICAL WIRING DIAGRAM NOTES174065-YIM-A-0206 Unitary Products Group174065-YIM-A-0206 Unitary Products GroupUnitary Products Group 5005 York Drive, Norman OklahomaSupersedes Nothing 174065-YIM-A-0206