HP B.06.X manual Step, Usr/bin/ps -e grep ppud

		Installing and Configuring PPU Software
		Getting Started
Step	3. Verify the ppud daemon is running on the system/partition by executing
		the following command:
		/usr/bin/ps -e grep ppud
		You should see the ppud daemon listed as an active process on the
		system/partition.
		If you do not receive the correct result for Step 3 (above) see “Manually
		Starting the ppud Daemon” on page 32 for details.
IMPORTANT		You need to configure the PPU software so your PPU system/partition
		communicates with the utility meter. PPU systems do not have the PPU
		software configured at the HP factory. See “Configuring PPU Software”
		on page 29 for details on configuring the utility meter settings.
		If Step 1, Step 2 and Step 3 (above) provide the correct results, your PPU
		system is compliant and no action is necessary for PPU software
		installation or configuration.

Chapter 3 25