HP B.06.X manual Return Values, Options

PPU Manpages

ppuconfig (1M) Manpage

Options

ppuconfig recognizes the following command-line options and arguments:

-mmeter Specifies the utility meter that the Pay Per Use system should use for reporting. The meter can be specified as a fully qualified hostname or IP address. A non-blank value is required.

-pproxy[:port] Specifies the proxy server that should be used by this system for HTTPS transmission if a proxy server is required. Optionally, a port number can be appended to the proxy server specification. Proxy configuration can be cleared by specifying an empty string (“”) as the proxy server value.

-ssystem_id	Specifies the system identifier that the Pay Per Use
	system should use when reporting. This can be any
	value that helps you to identify this system (for
	example, a tracking number, asset number, physical
	location, etc). Until a system identifier is specified, the
	hostname will be used by default.
-h	Specifies that the hostname should be used as the
	system identifier for the Pay Per Use system, when
	reporting usage information.
-u	Starts an interactive session to allow setting a
	username and password for the proxy server, if
	required by the proxy server. These values can be
	cleared by pressing Enter when prompted for a
	username.
-t	Perform communication test between Pay Per Use
	software and the configured utility meter.

RETURN VALUES

ppuconfig exits with one of these values:

0Success.

>0 Failure; error message sent to STDERR

74 Appendix D