Installing and Configuring PPU Software
|
|
|
|
| If you |
|
| by either |
|
| perform the following steps to restore your PPU configuration: |
Step | 1. | Manually save your PPU configuration file by backing up the following |
|
| file: /etc/ppu/ppu_config |
Step | 2. | Install the PPU software (see “Installing PPU Software” on page 26 for |
|
| details) |
Step | 3. | Restore your PPU configuration file (from Step 1): /etc/ppu/ppu_config |
Step | 4. | Start the ppud daemon (see “Manually Starting the ppud Daemon” on |
|
| page 32 for details) |
|
|
|
NOTE |
| An alternative method is to: install the PPU software and configure the |
|
| utility meter, thus starting the ppud daemon. |
|
|
|
Chapter 3 | 33 |