Installation
Mount Gun
Reciprocating Arm Rod Mount
To mount the gun on a reciprocating arm rod [0.5 in. (13 mm) diameter maximum]:
1.Insert the mounting bar (A) through the hole in the manifold as shown in FIG. 5.
Use the 1/8 in. alignment pin (P) to assist in orient- 
ing the gun.
2.Secure the gun to the bar by tightening the mount- ing screw (B).
2.Secure the gun to the support with two M5 x 0.8 capscrews (C). The screws must be long enough to engage the threaded holes in the gun manifold to a depth of 1/4 in. (6 mm).
C
TI8095 a
B
P
A
TI8094a
FIG. 6: Stationary Support Mount
Retrofit Adapter Plate
The retrofit adapter plate enables the manifold to be attached to a variety of bolt patterns.
To mount the gun using the retrofit adapter plate (kit 288197):
1. Mount adapter plate to manifold using the three |
FIG. 5: Reciprocating Arm Mount
Stationary Support
To mount the gun on a stationary support (refer to FIG. 6 and Mounting Hole Layout, page 35):
1.Align the manifold with the alignment pins. Locate alignment pins and holes per the Mounting Hole Layout illustration, page 35.
screws provided with the kit (FIG. 7). |
2. Bolt plate to mounting surface using four M5 x 0.8 |
capscrews. Refer to the Mounting Hole Layout, |
page 36. |
TI8180a
FIG. 7: Retrofit Adapter Plate Mount
12 | 311051D |