HP 2533t Mobile manual Select Start Run, All, Commit, Disable, Enable

Using the Enhanced Write Filter (EWF) command line control utility

CAUTION: Terminal Administrators should use Microsoft® Windows NT® file security to prevent undesired usage of these commands.

CAUTION: When using the

-commit

command, all of the temporary contents are permanently written to the flash memory.

NOTE: Because the Enhanced Write Filter commands are executed on the next boot, you must restart the computer for the command to take effect.

Windows® Embedded includes the EWF command line control utility. This utility enables you to issue a set of commands to the EWF driver, report the status of each protected volume overlay, and report the format of the overall EWF configurations.

By including the EWF Manager console component in your configuration and building it into your image, you enable use of the EWF command line control utility and the corresponding commands.

To use the Enhanced Write Filter command line control utility:

1.Select Start > Run.

2.Type

CMD

in the Open field to access the system DOS prompt.

3.Click OK.

4.Type ewfmgr c:

5.Press enter.

When you enter the ewfmgr -[boot command]

syntax, use the following commands in the boot command variable of the command line:

●-all

Displays information about all protected volumes and performs a command, such as disable, enable, and commit, on each volume, if specified.

●-commit

Commits all current level data in the overlay to the protected volume, and resets the current overlay value to 1. You can combine -commit with the -disable command to commit and then disable.

●-disable

Disables the overlay on the specified protected volume.

●-enable

14 Chapter 2 Enhanced Write Filter (EWF)