HP C5250, C5280, C5240 manual To load full-size paper

Chapter 1

HP All -in

-One overview

To load full-size paper

1.Raise the output tray to load paper into the main input tray.

2.Slide the paper-width guide to its outermost position.

3.Tap a stack of paper on a flat surface to align the edges, and then check the paper for the following:

•Make sure it is free of rips, dust, wrinkles, and curled or bent edges.

•Make sure all the paper in the stack is the same size and type.

4.Insert the stack of paper into the main input tray with the short edge forward and the print side down. Slide the stack of paper forward until it stops.

CAUTION: Make sure that the HP All-in-One is idle and silent when you load paper into the main input tray. If the HP All-in-One is servicing the print cartridges or otherwise engaged in a task, the paper stop inside the device might not be in place. You could push the paper too far forward, causing the HP All-in-One to eject blank pages.

TIP: If you are using letterhead, insert the top of the page first with the print side down.

6 HP All-in-One overview