HP C4599 Advanced firewall information, Manage your network settings, Print network settings

NOTE: Refer to your firewall documentation on how to configure the firewall port settings and how to add HP files to the "trusted" list.

NOTE: Some firewalls continue to cause interference even after you disable them. If you continue to have problems after configuring the firewall as described above, you might need to uninstall the firewall software in order to use the product over the network.

Advanced firewall information

The following ports are also used by your HP product and might need to be opened on your firewall configuration. Incoming ports (UDP) are destination ports on the computer while outgoing ports (TCP) are destination ports on the HP product.

•Incoming (UDP) ports: 137, 138, 161, 427

•Outgoing (TCP) ports: 137, 139, 427, 9100, 9220, 9500

The ports are used for the following functions:

Printing		Photo card upload
• UDP ports: 427, 137, 161		•	UDP ports: 137, 138, 427
•	TCP port: 9100	•	TCP port: 139
Scanning		Product status
•	UDP port: 427	UDP port: 161

•TCP ports: 9220, 9500

Faxing	Product installation
• UDP port: 427	UDP port: 427

•TCP port: 9220

Network setup

Manage your network settings

The HP All-in-One control panel enables you to perform a variety of network management tasks. This includes printing the network settings, restoring the network defaults, turning the wireless radio on and off, and printing a wireless network test.

Print network settings

You can print a network configuration page to see network settings such as the IP address, communication mode, and network name (SSID).

To print the network configuration page

1.Press the Wireless button on the product.

2.Press the button next to the down arrow on the display until Print Network Configuration Page is highlighted, and then press OK.

Restore network defaults

You can reset the network settings to what they were when you purchased the HP All-in- One.

Manage your network settings 9