OPERATING INSTRUCTIONS continued...
Loading
•Coal should never be added unless there is a reasonable hot fire. The coal bed should be bright and vigorous.
•If the fire is burning hot and there is a deep bed of coals, full loads of coal can be added at any time. However, if there is not a deep bed of coals, it is best to add small amounts of coal at first.
Increasing Heat From a Low Fire
•Every effort should be made not to let a coal fire burn too long so that the fire has started to die. This will cause the reloading process to be much longer, and there is a good possibility of losing the fire.
•Do not shake or stir with a low fire.
•Open the draft control wide or open the ash door fully open until the fire is reasonably hot.
•Start adding small amounts of coal. When the new coal is thoroughly ignited or there is a substantial bed of hot coals, the stove may be shaken thoroughly. Be sure to shake down all ashes (but do not overshake).
•After shaking, keep the bottom draft control open until you are sure the fire is continuing to burn hot, then turn the draft control down to the proper operating level. IF THE ASH DOOR HAS BEEN OPENED, BE SURE TO SHUT IT (SERI-
OUS DAMAGE CAN RESULT IF THE STOVE IS OPERATED FOR EXTENDED PERIODS WITH THE ASH DOOR OPEN).
•Count the exact number of turns from full shut to the normal operating positions so that you can adjust the stove to the exact level of heat output and length of burn you desire.
Shaking
•Shaking should be done only when there is a hot fire.
•The frequency of shaking will depend on the type of stove and the degree of burning. Shaking should be done at least once a day, and preferably twice a day.
•Best results from shaking with the grates will occur if short “choppy” strokes are used rather than long, even strokes.
•The amount of shaking is critical. Too little or too much, either can result in the extinguishing of a fire due to blocked air flow. The proper amount normally occurs when red coals first start to drop through onto the bed of ashes.
Draft Controls
•The heat output of the coal is controlled by the primary draft control on the bottom door. Experience will dictate the proper settings for heat requirements.
•Coal responds very slowly to changes in the draft settings. Because of this slow response time,
Ashes
•Ashes should never be allowed to accumulate in the ash pit so that they in any way impede the flow of combustion air to the fire. Excess ash accumulation can cause the fire to go out and also can cause severe damage to the grates because of the absence of a cooling flow of air beneath them.
•Ashes should be placed in a metal container with a tight fitting lid. The closed container of ashes should be placed on a
CAUTION! ASHES SHOULD NEVER BE ALLOWED TO ACCUMULATE ABOVE THE TOP OF THE ASH PAN. ASHES IN CONTACT WITH THE BOTTOM OF THE GRATES ACT AS AN INSULATOR, INTENSIFYING THE HEAT ON THE GRATES AND COULD CAUSE THEIR WARPAGE. WITH AN EXCESSIVE ASH BUILDUP, PRIMARY COMBUSTION AIR IS RESTRICTED, THUS THE UNIT’S OUTPUT COULD BE REDUCED.
GRATES DAMAGED IN THIS WAY ARE EASILY RECOGNIZED BY THE EXTREME DAMAGE CAUSED TO THE GRATES.
PLEASE REFER TO YOUR WARRANTY TO SEE UNITED STATES STOVES LIMIT OF LIABILITY IN CASES OF ABUSE OR NEGLECT.
Bituminous coal produces considerably more ashes than wood, so the intervals between emptying are much shorter. For equal heat output, coal will produce seven to ten times more ash than wood.
16 | USSC |