The following illustration shows the Front Cover setting and options. These options are the same for the Back Cover setting.
Figure 4-7 Front Cover setting
The Front Cover and Back Cover options are as follows:
●Add a Blank or Preprinted Cover check box
●Source is: drop-down menu
●Type is: drop-down menu
When you select Front Cover or Back Cover, also select the Add a Blank or Preprinted Cover check box to enable the setting. When this check box is selected, the Source is: and Type is:
NOTE: The Back Cover options are not available when the Booklet Layout setting is enabled on the Finishing tab. For
The Source is: setting specifies the source tray to use for adding a back cover to the document. The list of source trays depends on the installed accessories. Any optional paper trays that are installed through the Configure tab also appear here. For more information about the Source is: setting, see the Source is: on page 92 section of this chapter.
The Type is:
information about the Type is:
ENWW | Driver tabs 95 |