HP LP2275w 22-inch manual Using the Auto-Adjustment Function

Page 28

Using the Auto-Adjustment Function

You can optimize the screen performance for the VGA (analog) input by using the -/Autobutton on the monitor and the auto-adjustment pattern software utility on the CD provided.

Do not use this procedure if the monitor is using a DVI-D, HDMI, or DisplayPort input. If the monitor is using a VGA (analog) input, this procedure can correct the following image quality conditions:

●Fuzzy or unclear focus

●Ghosting, streaking or shadowing effects

●Faint vertical bars

●Thin, horizontal scrolling lines

●An off-center picture

To use the auto-adjustment feature:

1.Allow the monitor to warm up for 20 minutes before adjusting.

2.Press the -/Autobutton on the monitor front panel.

●You can also press the Menu button, then select Image Control > Auto Adjustment from the OSD Main Menu. Refer to Adjusting the Monitor Settings on page 25 in this chapter.

●If the result is not satisfactory, continue with the procedure.

3.Insert the CD in the disc drive. The CD menu is displayed.

4.Select Open Auto-Adjustment Software. The setup test pattern is displayed.

5.Press the -/Autobutton on the monitor front panel to produce a stable, centered image.

6.Press the ESC key or any other key on the keyboard to exit the test pattern.

22 Chapter 4 Operating the Monitor

Image 28

Contents HP LP2275w and LP2475w LCD Monitors Page About This Guide Iv About This Guide Table of contents Appendix a Troubleshooting Product Features HP LP2275w ModelHP LP2475w Model Page Safety and Maintenance Guidelines Important Safety InformationCleaning the Monitor Maintenance GuidelinesShipping the Monitor Setting Up the Monitor Installing the Monitor Pedestal BaseHP LP2275w Model Rear Components1HP LP2275w Rear Components HP LP2475w Model 2HP LP2475w Rear ComponentsSelecting and Connecting the Signal Cables 3Signal Connectors and CablesComponent Y Pb Connecting the Monitor Power Connecting USB Devices 5Connecting USB Devices Setting Up the MonitorAdjusting the Monitor Cable Management9Adjusting the Height Setting Up the Monitor Turning on the Monitor 10Pivoting the MonitorUsing the Accessory Rails Removing the Monitor Pedestal BaseMounting the Monitor 14Installing the Quick Release Setting Up the Monitor Locating the Rating Labels 15Inserting the Monitor Panel into the Quick ReleaseOperating the Monitor Software and UtilitiesInformation File Image Color Matching FileInstalling from the CD Installing the .INF and .ICM FilesDownloading from the Worldwide Web Using the Auto-Adjustment Function Front Panel Controls 1HP LP2275w Monitor Front Panel Controls2HP LP2475w Monitor Front Panel Controls PIP/POPAdjusting the Monitor Settings Using the On-Screen Display MenuOSD Menu 3OSD Menu Set On Time-sets the time you want the monitor to wake Factory default is Automatic Input Scan Using the HP Display Assistant Utility Optimizing Digital ConversionSleep Timer Mode Identifying Monitor ConditionsInstalling the HP Display LiteSaver Software HP Display LiteSaver4HP Display LiteSaver Configuration Options Changing the Color TemperatureSRGB Support Installing the sRGB ICM File for Microsoft Windows Vista Troubleshooting Solving Common ProblemsAppendix a Troubleshooting Using the Worldwide Web Preparing to Call Technical Support Technical Specifications Table B-1HP LP2275w SpecificationsTable B-2HP LP2475w Specifications Appendix B Technical Specifications Table B-3HP LP2275w Factory Preset Modes Recognizing Preset Display ResolutionsTable B-4HP LP2475w Factory Preset Modes Entering User Modes Energy Saver Feature Agency Regulatory Notices Federal Communications Commission NoticeModifications CablesAvis Canadien Canadian NoticeEuropean Union Regulatory Notice Japanese Power Cord Requirements Japanese Notice Korean Notice Power Cord Set RequirementsGerman Ergonomics Notice Energy Star Compliance Product Environmental NoticesMaterials Disposal Restriction of Hazardous Substances RoHS LCD Monitor Quality and Pixel Policy