DECLARATION OF CONFORMITY
According to ISO/IEC Guide 22 and CEN/CENELEC 45014
Manufacturer’s Name: | |||
Manufacturer’s Address: | 5, Avenue Raymond Chanas - EYBENS | ||
|
|
| 38053 GRENOBLE CEDEX 09 |
|
|
| FRANCE |
declares, that the product: |
| ||
Product Name: |
| HP 17” Color Monitors | |
Model Number: |
| D8901A, D8902A | |
conforms to the following product specifications: | |||
SAFETY | - International: IEC 60950:1991 + A1 + A2 +A3 +A4 / | ||
| - Europe: | EN 60950:1992 + A1 + A2+A3 + A4 | |
EMC | - CISPR 22:1993+A1 + A2 / EN 55022:1994 + A1 +A2 Class B1) |
- EN
IEC
IEC
-IEC
-IEC
-
-FCC Title 47 CFR, Part 15 Class B2)
-
-VCCI-B
-AS/NZ 3548:1992
Supplementary information: The product herewith complies with the requirements of the following Directives and carries the
EMC Directive 89/336/EEC and the Low Voltage Directive 73/23/EEC, both amended by the Directive 93/68/EEC.
1)The product was tested in a typical configuration with
2)This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and
(2)This device must accept any interference received, including interference that may cause undesired operation.
| Jean Marc JULIA |
Grenoble, 26 May 1999 | Quality Manager |
For Compliance Information ONLY, contact:
USA contact: Hewlett Packard Company, Corporate Product Regulations Manager, 3000 Hanover Street, Palo Alto, CA 94304. (Phone (415)
Notice for the USA: FCC Statement
Federal Communications Commission (FCC) Radio
Frequency Interference Statement (USA Only)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protections against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try one of more of the following measures:
•Relocate the radio or television antenna.
•Move the computer away from the radio or television.
•Plug the computer into a different electrical outlet, so that the computer and the radio or television are on separate electrical circuits.
•Make sure that all your peripheral devices are also FCC Class B certified.
•Make sure you use only shielded cables to connect peripheral devices to your computer.
•Consult your computer dealer,
WARNING
Changes or modifications not expressly approved by
Safety Warning for USA
If the power cord is not supplied with your monitor, select the proper power cord according to your national electric safety codes.
USA: use a UL Listed Type SVT or Type SJT detachable power cord.
Notice for Japan