4.Tire changing equipment
5.Tire balancing equipment
3.3Tire Sensor Installation
1.Remove the wheel from the vehicle and then remove the tire.
2.Wrap the strap around the rim in the lowest point of the drop center well and mark it 1” (2.5 cm) past the worm gear. Cut the strap at the mark. Excess strap MUST be removed or it will
3.Slide on the sensor.
1"
Figure 4
4.With the strap and sensor positioned in the lowest point of the center well, feed the end of the strap into the worm gear and pull it tight. Orient the sensor so that it is positioned at the valve with the worm gear 4" (10 cm) away from the edge of
the sensor. The sensor MUST always |
|
be installed at the valve in order to know |
|
its approximate location after the tire has |
|
Figure 5 | |
been mounted. |
|
5.Tighten the strap using a 5/16" (8 mm) hexagon driver until the sensor can not be moved. Reference torque: 35
CAUTION: Do not over tighten the strap.
6.Indicate the location of the sensor by applying the supplied rim label to a clean and dry location on the rim.
Figure 6 - The actual label design may vary
15