BENDIX BW2920 SmarTire Tpms System Q&A, Diagnosing a Defective, Missing, Or Misplaced Sensor

Page 46
Figure 47

7.2SmarTire® TPMS System Q&A

7.2.1Q: A trailer tire continues to show a deviation value/alert although it was aired up properly.

A:Set the Cold Inflation Pressure value (CIP) for each trailer axle to make sure it matches that of the intended inflation value for the tire in question. To do so, please refer to Section C, 4.2.2 as well as the inflation tables in

Section A under Section 1.4. If the CIP value is matched to the recommended inflation pressure for the vehicle and the prevailing ambient temperature but the deviation value continues to show up, the tire is exhibiting a slow leak. Take appropriate steps to have the tire inspected for any damage or leaks.

7.2.2Q: Pressure readings at a tire location do not change on the gauge when air is added, or removed, to correct tire pressure, and a new transmission has been received.

A:Wheel assemblies may have been relocated/rotated on the trailer without the SmarTire Trailer-LinkECU having been updated. To correct this, follow the steps in Section C, 4.2.3 in combination with the SmarTire® TPMS Maintenance Hand tool to relearn sensors into their correct tire positions.

7.3Diagnosing A Defective, Missing, Or Misplaced Sensor

In the event that a tire sensor does not report to the display after having gone through the steps above, the following sensor checks should also be performed:

a.Try to initiate the sensor opposite of the valve stem. There are times when the tire installer accidentally places the sensor 180 degrees opposite of the valve by misreading the instructions (sensors are required to be placed 180

degrees opposite of each other for dual wheel assemblies). Check for new data on the gauge for the affected wheel position.

b.If step a. was unsuccessful, try to initiate the sensor at the bottom of the wheel, no matter where the valve stem is located. If this attempt updated the display screen, rotate the wheel 180 degrees forward and initiate the sensor again at the BOTTOM of the wheel. If the second initiation also provided new data (cycle power between tries to empty the screen, not necessary when using SmarTire Maintenance Hand tool), it is evidence of a broken cradle and/or strap. The sensor is simply falling to the lowest point in the wheel after each rotation. Remove the tire and replace the cradle and strap. Depending on the damage done to the sensor itself,

46

Image 46
Contents SmarTire Trailer-LinkTPMS Page Index General Safety Guidelines System Features Bendix SmarTire System AdvantagesImportant Notice Please Read Maintenance Tool Section a System Overview System ComponentsHow Does The SmarTire Trailer- Link Tpms System Work? Fundamentally, Why Is Temperature Monitoring Important? Pressure/Temperature RelationshipChart SmarTire Trailer-LinkTPMS Temperature Compensation Thermal EquilibriumTire Maintenance Maintenance Tips for Long Tire LifeRead These Instructions Prior to Installation Section B System Installation Tire Sensors Sensor Overview Tools RequiredTire Sensor Installation Remove the wheel from the vehicle and then remove the tireRe-mounting Tires After a Sensor Has Been Installed Internal Tire Sensor ServicingRe-Mounting Tires Using Tire Irons Re-Mounting Commercial Tires Using a Vertical Tire Machine Dual Wheel Assemblies Re-Mounting Light Truck Tires Using a Tire MachineOutboard Tire Removing a Tire That Has a SmarTire Tpms Sensor Installed Using Tire IronsUsing a Tire Mounting Machine Tire Sensor Specifications Page SmarTire Trailer-LinkTPMS ABS Power Splice Part No K075867 Ft SmarTire Trailer-LinkTPMS Harness Part No K075868 Page Configuring & Customizing Your SmarTire Trailer-LinkSystem Pre-Configured SettingsTrailer CIP Programming Procedure EquipmentPage Trailer Sensor ID Walk-Around Learn Procedure Outboard Tire Inboard Tire Inch LF Field Range Valve StemPage Page Page Tractor SmarTire Tpms Dash Display Alerts Trailer Lamp Blink CodesSetup Cause and SolutionDiagnostic Tpms Lamp AlertsPage Dimensions in Inches/mm Position SignalBack View Page Link ECU Outboard Tire Inboard Tire Page What additional diagnostic information is available? Alarms Priority External LED SeePage SmarTire Tpms System Q&A Diagnosing a Defective, Missing, Or Misplaced SensorSmarTire Tpms Hand Tool Troubleshooting No tire pressure sensor data is receivedAppendix 1 Replacement Parts DescriptionUse Of Chemicals System Installation And UsageReacting To Alerts Federal Communications Commission FCC Notice Page On-line training thats available when you are 24/7/365 Log-on and Learn from the Best