BENDIX BW2920 SmarTire Tpms Hand Tool Troubleshooting, No tire pressure sensor data is received

it may simply be pressed into a new cradle for reuse. Avoid reusing the strap – worm gear could be damaged internally.

c.If points a. and b. did not yield any results, the sensor is either missing or has been damaged. Remove the wheel carefully and inspect the inside tire lining for any damage if the sensor, strap, and cradle are found to have been damaged and non-operational. Replace strap, cradle, and sensor. Program the new ID into the system using the SmarTire® TPMS Maintenance Hand tool as described in Section C, 4.2.3.

7.4SmarTire® TPMS Hand Tool Troubleshooting

7.4.1Q: The Tool does not power-up or turns off when the “Activate” button is pressed.

A: Replace the batteries.

7.4.2 Q: No tire pressure sensor data is received.

A:Make sure the Activate Antenna is held within 6" of the tire pressure sensor and positioned before the “Activate” button is momentarily pressed and that the tool is held in that position for at least 3.5 to 5 seconds. Try to activate and receive tire pressure sensor data from another tire sensor.

	Activate Antenna
On/Off
Button
	Display Screen
Flash	Selection
Connector
	Buttons

Figure 48

47