2.6 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place jumper caps over these headers and connectors. Placing jumper caps over the headers and connectors will cause permanent damage of the motherboard!
FDD connector
(see p.12 No. 27)
the
Note: Make sure the
Primary IDE connector (Black)
connect the blue end | connect the black end |
to the motherboard | to the IDE devices |
Note: Please refer to the instruction of your IDE device vendor for the details.
Serial ATA2 Connectors |
| SATAII_6 | |
|
|
| |
(SATAII_1 (PORT 0): see p.12, No. 20) |
| (PORT 5) | |
(SATAII_2 (PORT 1): see | p.12, No. 19) |
|
|
(SATAII_3 (PORT 2): see | p.12, No. 18) |
|
|
(SATAII_4 (PORT 3): see | p.12, No. 17) |
| SATAII_5 |
(SATAII_5 (PORT 4): see | p.12, No. 16) |
| (PORT 4) |
|
| ||
(SATAII_6 (PORT 5): see | p.12, No. 15) | SATAII_2 | SATAII_4 |
|
| (PORT 1) | (PORT 3) |
|
| SATAII_1 SATAII_3 | |
|
| (PORT 0) | (PORT 2) |
These six Serial ATA2 (SATA2) connectors support SATA data cables for internal storage devices. The current SATA2 interface allows up to 3.0 Gb/s data transfer rate.
Serial ATA3 Connectors | SATA3_2 | |
|
| |
(SATA3_1 (PORT 6): see | p.12, No. 11) | (PORT 7) |
(SATA3_2 (PORT 7): see | p.12, No. 9) |
|
SATA3_1 (PORT 6)
These two Serial ATA3 (SATA3) connectors support SATA data cables for internal storage devices. The current SATA3 interface allows up to 6.0 Gb/s data transfer rate.
20