ASRock 2Core1066-2.13G manual PCIPnP Configuration, A.R.T, Bit Data Transfer, PCI Latency Timer

Page 35

S.M.A.R.T.

Use this item to enable or disable the S.M.A.R.T. (Self-Monitoring, Analysis, and Reporting Technology) feature. Configuration options: [Disabled], [Auto], [Enabled].

32-Bit Data Transfer

Use this item to enable 32-bit access to maximize the IDE hard disk data transfer rate.

3.3.5 PCIPnP Configuration

BIOS SETUP UTILITY

Advanced

Advanced PCI / PnP Settings

PCI

Latency Timer

[32]

PCI

IDE BusMaster

[Enabled]

Value in units of PCI clocks for PCI device latency timer register.

 

Select Screen

 

Select Item

+-

Change Option

F1

General Help

F9

Load Defaults

F10

Save and Exit

ESC

Exit

v02.54 (C) Copyright 1985-2005, American Megatrends, Inc.

PCI Latency Timer

The default value is 32. It is recommended to keep the default value unless the installed PCI expansion cards’ specifications require other settings.

PCI IDE BusMaster

Use this item to enable or disable the PCI IDE BusMaster feature.

3 5

Image 35
Contents 2Core1066-2.13G Disclaimer Copyright NoticeContents Software Support Introduction Package ContentsSpecifications Support CD ConnectorBios Feature See CautionDDRII533*, DDRII667 VGA 22.9cm 9.0 Motherboard LayoutTable for Audio Output Connection HD 8CH I/OScrew Holes Pre-installation PrecautionsCPU Installation Land CPU Installation of CPU Fan and Heatsink Installing a Dimm Installation of Memory Modules DimmExpansion Slots PCI, Hdmr and PCI Express Slots Installing an expansion cardPS2USBPWR1 Jumpers SetupIDE1 Onboard Headers and ConnectorsUSB 2.0 Headers Chassis Speaker Header Serial port Header Western Digital Sataii Hard Disk Setup GuideUntied Overclocking Technology Driver Installation GuideHdmr Card and Driver Installation Bios Menu Bar Advanced Screen Navigation KeysMain Screen CPU Configuration No-Excute Memory Protection Enhance Halt StateMax Cpuid Value Limit CPU Thermal ThrottlingChipset Configuration Dram RAS# Activate to Precharge Internal Graphics Mode SelectDvmt Mode Select Dram RAS# PrechargePCI Fix Function Front PanelCD-In OnBoard LanAcpi Configuration ATA/IDE Configuration Enhanced IDE ConfigurationATA/IDE Configuration IDE Device ConfigurationBlock Multi-Sector Transfer LBA/Large ModePIO Mode DMA ModeBit Data Transfer PCIPnP ConfigurationPCI Latency Timer A.R.TSerial Port Address Floppy ConfigurationSuper IO Configuration OnBoard Floppy ControllerUSB Configuration Tolerance C Target CPU Temperature CHardware Health Event Monitoring Screen CPU Quiet FanBoot Up Num-Lock Boot ScreenBoot Settings Configuration Boot From Onboard LANSecurity Screen Main Advanced Monitor BootChange Supervisor Password Discard Changes and Exit Load Optimal DefaultsExit Screen Save Changes and ExitDrivers Menu Install Operating SystemSupport CD Information Running The Support CD