MSI FUZZY 945GME1, FUZZY 945GM1 manual Award Post Code, ∙ Error/Process Message

System Resources

Award POST Code

Award BIOS Error Message and Check Point (POST code) List (Need to be modified, TBD)

∙Error/Process Message.

#	Short Name	Description	Possible FRUS
1	CMOS	Checksum of CMOS is incorrect, so the	System board
	checksum error	system loads the default equipment
	- Defaults	configuration. A checksum error may
	loaded	indicate that CMOS has become corrupt.
		This error may have been caused by a
		weak battery. Check the battery and
		replace if necessary.
2	CPU at nnnn	Displays the running speed of the CPU.	processor
3	Press ESC to	The user may press Esc to skip the full	System board
	skip memory	memory test.
	test
4	Floppy disk(s)	Cannot find or initialize the floppy drive	system board
	fail	controller or the drive. Make sure the
		controller is installed correctly. If no floppy
		drives are installed, be sure the Diskette
		Drive selection in Setup is set to NONE or
		AUTO.
5	HARD DISK	Some hard drives require extra time to	System board
	initializing	initialize.
	Please wait a
	moment
6	HARD DISK	Cannot find or initialize the hard drive controller	System board
	INSTALL	or the drive. Make sure the controller is
	FAILURE	installed correctly. If no hard drives are
		installed, be sure the Hard Drive selection in
		Setup is set to NONE.
7	Keyboard error	Cannot initialize the keyboard. Make sure	System board
	or no keyboard	the keyboard is attached correctly and no
	present	keys are pressed during POST. To
		purposely configure the system without a
		keyboard, set the error halt condition in
		Setup to HALT ON ALL, BUT KEYBOARD.
		The BIOS then ignores the missing
		keyboard during POST.
8	Memory Test:	This message displays during a full	DIMM
		memory test, counting down the memory	System board
		areas being tested.

4-5