Raypak Y-200 manual Password, Setup, S S W O R D, To enter the password, B S S S a a a

Password:

Screen number

P A S S W O R D 1 9

A A A

Used by maintenance personnel to change settings.

In display mode shows AAA or current password.

To enter the password:

1.Push the mode key. The cursor under the first A should start flashing.

2.Change the first letter by using the up or down key to the desired letter. Use the right key to go to the next letter and change it with the up or down key. Do the same to the last letter then push the mode key when done.

• If the password is valid, the screen will allow the user to change to the first setup screen.

Setup:

					Screen number
U N	I T	S	E T — U	P	2 0
M A	S T	E R	P B	S	B S B S S S A A A

P=	SYSTEM PUMP MODULE
	Rule: Always on before boiler. Always off after last boiler off + programmed delay.
	P is relay #1 as supplied.	Not Programmable.
B=	INDICATES BOILER	NOTE: B represents the boiler and stage one of that boiler.
	Rule: Always B before S	Example: A 4-Stage boiler = BSSS
S=	INDICATES BOILER STAGE
	Rule: Must have "B" for that boiler ON and prior stages ON for that boiler.
	See example above.
A=	AUXILIARY RELAY MODULE
	Optional: A1 - User defined function. (i.e. powered louvers, boiler pump, draft fan)
	A2 - User defined function. (i.e. alarm light)
	A3 - User defined function. (i.e. alarm bell)
	NOTE: Piezo-electric alarm horn can be silenced by pressing the "MODE" switch.
		Table K: Definitions

28