3Attach the seal strip to the window.
4Install the unit in the window.
Use hand grips on top sides of unit as an aid in lifting and positioning unit.
Be sure bottom edge of unit fits down into “L” bracket (type “E”).
5Extend the window filler panels.
on both sides. When the window is pulled down, the window should rest on the unit just behind the window filler panel frames.
Secure the both sides of the window filler panels using the 2 type “A” wood screws provided.
Install the 2 type “C ” window filler panel clamp to each side of lower the window filler panel frame as shown in the figure by using
the 2 type “A” wood screws.
Install the 2 type “D ” window filler panel clamp to each side of upper the window filler panel frame as shown in the figure by using
the 2 type “A” wood screws.
6Install the window gasket.
Cut the foam window gasket to the window width and stuff it between the window and the glass to prevent air and insects from getting into the room.
“L” Bracket (Type “E”) |
Type “A” screws |
Type “A” screw
Window filler panel clamp (Type “D”)
Window filler panel clamp (Type “C”)