GE AEM25*, AEH25*, AEM18*, AEH18* Care and cleaning of the air conditioner, Operating Instructions

Page 8

Safety Instructions

 

 

Operating

Instructions

 

Care and Cleaning

 

 

Installation

Instructions

Tips

Troubleshooting

Care and cleaning of the air conditioner.

Grille and Case

Turn the air conditioner off and remove the

To clean, use water and a mild detergent. Do not

plug from the wall outlet before cleaning.

use bleach or abrasives.

Outdoor Coils

The coils on the outdoor side of the air conditioner should be checked regularly. If they are clogged with dirt or soot, they may be professionally cleaned.

Air Filter

The air filter behind the front grille should be checked and cleaned at least every 30 days or more often if necessary.

To remove:

1

Open the inlet grille upward by pulling out the

bottom of the inlet grille.

 

 

Using the tab, pull up slightly on the filter

2

to release it and pull it down.

 

Clean the filter with warm, soapy water. Rinse and

let the filter dry before replacing it. Do not clean

the filter in a dishwasher. CAUTION: DO NOT operate the air conditioner without a filter because dirt and lint will clog it and reduce performance.

Grille Frame Removal (if necessary for coil cleaning)

Remove the air filter. See the Air Filter section above.

If present, remove the grille frame attachment screw.

Grasp the lower corners of the grille frame while pressing in on the case side tabs with your finger tips. Pull out to release and lift it up.

NOTE: Do not pull the bottom edge toward you more than 3″ or you may damage the tabs of the grille.

How to Insert the Batteries in the Remote Control

Consumer Support

1

2

3

Remove the battery cover by sliding it according to the arrow direction.

Insert new batteries, making sure that the (+) and (–) of battery are installed correctly.

Reattach the cover by sliding it back into position.

NOTES:

■Use 2 “AAA” (1.5 volt) alkaline batteries. Do not use rechargeable batteries.

■Remove the batteries from the remote control if the system is not going to be used for a long time.

8

Page 7 Page 9
Image 8
Page 7 Page 9
Contents 49-7587 11-07 JR Write the model and serial numbers here Model # Serial #Tips Consumer Support Do not use an adapter plug with this applianceGe.com Instructions Installation TroubleshootingInstructions Safety Instructions Care and CleaningSupport ConsumerCool Mode Safety Instructions Energy Saver ModeFan Only Mode Power Outage Recovery FeatureMode Control InstructionsCare Temp ControlNormal operating sounds Instructions InstallationAdditional controls Operating Instructions Care and cleaning of the air conditionerInstallation Instructions Tips Tools YOU will Need Before YOU BeginElectrical Requirements Window Installation Instructions Parts IncludedWindow Requirements Storm Window RequirementsRemove the AIR Conditioner from the Case Prepare the WindowInstall the Case in the Window Prepare the CaseInstall the Case Install Support Brackets and the Foam TOP Window GasketInstall the AIR Conditioner in the Case Install the AIR Conditioner in the CaseThrough-the-Wall Installation Instructions-Optional Finish the Wall OpeningProblem Possible Causes What To Do Troubleshooting TipsInstallation Instructions We’ll Cover Any Appliance. Anywhere. Anytime Consumer Product Ownership Registration GE Air Conditioner Warranty GE Will ReplaceSchedule Service Parts and AccessoriesConsumer Support GE Appliances Website Real Life Design StudioAcondicionadores de Aire Seguridad ¡ADVERTENCIA Instalación Cuidado y limpieza Solucionar Problemas SeguridadInstalación Cuidado yLimpieza Instalación Cuidado y Solucionar Problemas Control de modoControl de Temp Descripciones de enfriamientoSonidos de operación normales Problemas SolucionarControles adicionales Seguridad Operación Solucionar ProblemasCuidado y limpieza del acondicionador de aire Antes DE Iniciar Requisitos EléctricosHerramientas QUE Necesitará Partes IncluidasPrepare LA Ventana Requisitos Para LA VentanaRequisitos DE UNA Ventana DE Tormentas Prepare LA Caja Instale LA Caja EN LA VentanaInstale LA Caja Instale Soportes DEInstale EL Acondicionador DE Aire EN LA Caja Instrucciones de instalación a través de la pared-opcional ImportanteTermine LA Abertura EN LA Pared Seguridad Operación Cuidado y limpieza Instalación Solucionar problemasProblema Causas posibles Qué hacer Seguridad Operación Instalación Cuidado y limpieza Se acumula agua enLa bandeja Retardo 1-24h no estáGarantía de su acondicionador de aire de GE GE reemplazaráLo que no está cubierto Garante General Electric Company. Louisville, KYApoyo al consumidor Página Web de GE Appliances Solicite una reparaciónGarantías ampliadas Piezas y accesorios

AEH18*, AEM18*, AEH25*, AEM25* specifications

General Electric (GE) has made significant strides in the evolution of its gas turbine technology with the introduction of the AEM18*, AEM25*, AEH25*, and AEH18* series. These models are engineered to meet the growing demands for efficient, reliable, and environmentally responsible energy generation.

The AEM18* and AEM25* models focus on advanced aerodynamics and materials science to deliver high efficiency and performance. These turbines utilize a state-of-the-art combustion system that enables low emissions operation while maintaining operational flexibility. The AEM series is renowned for its capabilities in combined cycle applications, offering a high power-to-weight ratio which enhances overall system efficiency.

The AEH25* and AEH18* models build upon the advanced technology established in the AEM series but introduce enhancements aimed at heavy-duty and industrial applications. With innovative design modifications, including improved rotor dynamics and robust cooling techniques, these turbines achieve excellent reliability and availability. The AEH series is designed with high operational flexibility, capable of handling high load variations while providing consistent performance.

All four turbine models share GE's commitment to utilizing advanced digital technologies, including the Predix platform, which harnesses the power of analytics. This technology allows operators to monitor performance in real time, predict maintenance needs, and optimize operational parameters, resulting in reduced downtime and improved efficiency.

In terms of characteristics, the AEM and AEH series turbines are characterized by their modular design, which simplifies installation and maintenance processes. This design allows for easier upgrades and retrofits, ensuring that customers can adapt their systems to future technological advancements.

The environmental impact of these gas turbines cannot be understated. Both the AEM and AEH series are designed to meet rigorous emissions standards, showcasing GE's commitment to sustainability. With reduced greenhouse gas emissions and the capacity to integrate with renewable energy sources, these turbines serve as a key component in the transition to cleaner energy systems.

In summary, the GE AEM18*, AEM25*, AEH25*, and AEH18* turbines represent a culmination of innovative engineering, advanced technology, and a focus on environmental sustainability, making them suitable choices for a variety of energy generation applications in today's dynamic energy landscape.
Top Page Image Contents