Paradyne BSX8000-5, Broadband Services Switch Unpacking and Inspecting the Equipment

Unpacking and Inspecting the Equipment

HANDLING PRECAUTIONS FOR ! STATIC-SENSITIVE DEVICES

This product is designed to protect sensitive components from damage due to electrostatic discharge (ESD) during normal operation. When performing installation procedures, however, take proper static control precautions to prevent damage to equipment. If you are not sure of the proper static control precautions, contact your nearest sales or service representative.

If there is any visible damage, do not attempt to connect the device. Contact your sales or support representative

Installing a Micro Interface Module (MIM) in the BSX8000-5

A MIM provides the upstream network connection for the BLC. Any of Paradyne's available MIM models may be installed on the BSX8000-5 uplink module.

Procedure

1.Remove the cover plate from the MIM port.

CAUTION: Cover plates should be stored for possible future use. If a MIM is removed from a BSX8000-5, it must be replaced with either another MIM or a cover plate. Do not operate a BSX8000-5 with an open MIM port.

2.Carefully slide the faceplate of the MIM into the BSX8000-5 uplink module faceplate. Ensure that the mounting holes on the MIM are lined up with the BSX8000-5 uplink module.

3.Secure the MIM circuit board to the BSX8000-5 uplink module with the two thumbscrews.

4 March 2005 BSX8-A2-GZ40-10