Cooling Your Room
You must select the COOL mode if you wish to adjust the :
◆Cooling temperature
◆Fan speed when cooling
1 If necessary, press 
(ON/OFF) button.
Result: ◆ The On/Off indicator on the unit comes on.
◆ The air conditioner runs in the mode selected when the unit was last used.
◆The indoor unit beeps.
IMPORTANT The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being:
◆ Plugged in ◆ Stopped
lt will start up normally after three minutes.
2To select the COOL mode, press the Mode button until 
is displayed
at the top of the wireless remote controller.
Result: ◆ The indoor unit beeps.
◆ The air conditioner runs in COOL mode.
Note You can change modes at any time.
3To adjust the temperature, press the Temperature buttons one or more
times until the required temperature is displayed. Possible temperatures are between 18OC and 30OC inclusive.
Result: ◆ Each time you press Temperature buttons: - The temperature is adjusted by 1OC.
- The indoor unit beeps.
◆ The air conditioner starts cooling, provided that the room
◆ temperature is higher than the selected temperature ; the fan ◆ will, however, operate.
4Select the fan speed by pressing the Fan button one or more times until the intended value is displayed :
Automatic(rotated : 
➔ 
➔ 
)
Low
Medium
High
5 To control the direction of the air flow, refer to page 25.