122XL Copper Cutting and Prep Machine
5.Reinstall nut and washer and tighten by again holding the shaft stationary. Apply sufficient torque to the nut to prevent the disk from turning.
Machine Storage
WARNING
Service and Repair
WARNING
Figure 11 – Assembling Deburring Disk
Motor
Motor is equipped with a thermal overload that turns off the motor in the event it develops excessive heat.
To reset the thermal overload, wait approximately 15 minutes for the motor to cool and remove the bottom cover. Press the red button located on the end of the motor opposite the reamer.
WARNING To prevent electrical shock, make sure machine is unplugged from power source before remov- ing cover.
Replace the cover and plug the machine into an elec- trical outlet. Turn the ON/OFF switch to the ON position. If motor does not start or the thermal overload continu- ally trips during normal use, the machine should be taken to an Authorized Service Center.
Service and repair work on this Copper Cutting and Prep Machine must be performed by qualified repair personnel. Machine should be taken to a RIDGID Independent Authorized Service Center or returned to the factory. All repairs made by Ridge service facilities are warranted against defects in material and workmanship.
When servicing this machine, only identical replace- ment parts should be used. Failure to follow these instructions may create a risk of electrical shock or other serious injury.
If you have any questions regarding the service or repair of this machine, call or write to:
Ridge Tool Company Technical Service Department 400 Clark Street
Elyria, Ohio
For name and address of your nearest Independent Authorized Service Center, contact the Ridge Tool Company at (800)
Wiring Diagram
115V – 60Hz
100V – 50/60Hz
(220 – 240V/50Hz)
| Switch |
|
Black (BRN) | Back View |
|
Black |
| |
White (BLU) | White | Motor |
Green | Green |
|
| Chassis |
|
| Ground |
|
10 | Ridge Tool Company |
