RIDGID 122XL manual Machine Assembly, Specifications, Standard Equipment, Accessories

122XL Copper Cutting and Prep Machine

tubing. The brush cleans the external surface in prepa- ration for joining. Deburring disk cleans burrs from the out- side surface of the tubing.

Model 122XL Copper Cutting And Prep Machine can also clean the inside of fittings using individually sized brushes that are attached to motor-driven quick change adapter. It can also be used to cut and debur 1/2″ through 4″ stainless steel tubing with a maximum wall thick- ness of .065″.

Specifications

Capacity	1/2″ – 4″ Diameter
	Copper Tube & Fittings
	(Types K, L, and M)
	(Stainless Steel Tube 0.065″
	Maximum Wall Thickness)
Maximum
Reamer Capacity	2″ Diameter Tubing
Motor:
Type	115V/60Hz Induction
Horsepower	1/3 HP @ 1750 RPM
Amps	6.0
Switch	ON
	Rocker Type
Weight	OFF
	72 lbs. (32.7 kg)
Dimensions:
Height	16.5″ (42 cm)
Width	17.1″ (43 cm)
Depth	17.0″ (38 cm)

Standard Equipment

Model No.	Cat. No.	Description
122XL	10973	Copper Cutting and Prep Machine
		115V, 60Hz w/Reamer and O.D
		Deburring Disk

Accessories

Cat. No.	Description
36662	Model 301A Foot Switch – 120V
93717	1/2″ Fitting Brush (Pkg. of 3)
93722	3/4″ Fitting Brush (Pkg. of 3)
93727	1″ Fitting Brush (Pkg. of 3)
93732	11/4″ Fitting Brush (Pkg. of 3)
93737	11/2″ Fitting Brush (Pkg. of 3)
93742	2″ Fitting Brush (Pkg. of 3)
12638	21/2″ Fitting Brush (Pkg. of 3)
12643	3″ - 4″ Fitting Brush (Pkg. of 3)
93747	Quick-Change Adapter f/Fitting Brush
93712	Fitting Brush Holder
33551	Cutter Wheel f/Copper and Stainless Steel
10343	Wheel Pin for 33551 Cutter Wheel
42295	Outside Diameter Cleaning Brush
42360	1206 Stand

Figure 1 – 122XL Copper Cutting and Prep Machine

Fitting

Brushes

Adapter

Figure 2 – Fitting Brushes/Quick-Change Adapter, and Mounting Hardware

Machine Assembly

WARNING

To prevent serious injury, proper assembly of the No. 122XL Copper Cutting and Prep Machine is required. The following procedures should be followed:

WARNING Make sure machine is unplugged from power source before assembling accessories or making any adjustments.

Fitting Brushes and Holder

(Optional Accessory)

1.Mount the fitting brush holder to No. 122XL Copper Cutting and Prep Machine by using the two Phillips head screws provided with the rack (Figure 2). Use the two pre-drilled holes to fasten the rack to the side of the housing.

2.Attach the quick change adapter to front roller shaft extending from the machine housing using the set

4 Ridge Tool Company