POWER BRUSH
VACUUMING WITH THE POWER BRUSH
1. Attaching the Power Brush
The hose must be plugged into the canister and the power brush must be plugged into the hose and extension wand.
2. Vacuuming
•For best results, move the power brush slowly using short, overlapping strokes.
•For heavily soiled areas, repeat strokes in several directions.
•Push the height adjustment button to match the surface being cleaned.
•Press the height adjustment button at the bottom of the wand until it clicks.
Do not invert the power brush while it is running.
CAUTION
3.Checking the Performance of the Power Brush
You can check whether the power brush is operating correctly by lifting up the extension tube slightly to view the back of the brush.
The Power Brush will not operate when it is jammed or the unit is turned off.
If the Power Brush is jammed, unplug the power cord from the electrical outlet. Turn the power brush over and remove the jammed object.
Turn the power brush back to the vacuuming position and resume vacuuming.
OVERLOAD PROTECTOR
The overload protector shuts off the brush motor if the fl oor brush becomes obstructed, the fl oor brush will stop, but the suction motor will continue to run. To reset the overload protector, turn the vacuum off and unplug it. Clear the obstruction from the fl oor brush area. Use a pen tip to press down the reset switch. Turn the vacuum on and continue cleaning.
Reset S/W
8_ operating the vacuum