Samsung VCC88P0H1B user manual Maintaining Floor Tools, Parquet Brush Optional

Page 10

MAINTAINING FLOOR TOOLS

CHECKING the Rotating Floor Brush and Drive Belt

You should check your vacuum cleaner’s rotating ﬂ oor brush and drive belt regularly for wear or damage. You should also clean strings, hair, and carpet ﬁ bers off the brush and brush ends. These can wrap around the brush and hamper its ability to effectively clean your carpet. Also remove any debris that has accumulated under the brush cover.

1.Unplug the vacuum from the electrical outlet.

2.Place the handle in low position and turn the vacuum cleaner over so the bottom side is up.

3.Remove the six screws (at arrows, right) with a screwdriver.

4.Remove the brush cover from the ﬂ oor brush.

5.Grasp the rotating ﬂ oor brush at both ends and lift.

6.Clean string, hair and other debris off the rotating ﬂ oor brush, paying particular attention to brush ends.

7.Clean string, hair and other debris off the motor pulley and drive belt areas.

8.Check the drive belt carefully for wear, cuts or stressed areas.

9.Check the air passageway for obstructions. Remove debris from this area.

The rotating ﬂ oor brush could cause the fringe of a rug

CAUTION to become tangled within the vacuum.

Use caution and turn off the ﬂ oor brush when vacuuming throw rugs with fringe.

Brush Cover

REPLACING the Drive Belt

1.Make sure that the vacuum is unplugged.

2.With the rotating ﬂ oor brush removed from the vacuum

cleaner, grasp the old drive belt and remove it from the motor pulley. Discard the old drive belt.

3. Place the new drive belt over the motor pulley and stretch

the other end over the rotating ﬂ oor brush in the space between the bristles.

4. Place the ends of the rotating ﬂ oor brush down into the slots on the sides as shown.

5.Turn the rotating ﬂ oor brush by hand several times in the direction of the motor pulley. If properly installed, the drive belt will center itself on the rotating brush crown.

6.Reposition the brush cover and screws. Tighten the screws securely.

PARQUET BRUSH (OPTIONAL)

•Vacuums dust in a wide area at once.

• Remove waste matter completely from the inlet if the inlet is blocked.

10_ maintaining the tools and ﬁlters

Image 10

Contents Vacuum Cleaner Other Symbols Used Safety informationSafety Information Polarized Plug InstructionsImportant Safety Instructions Read ALL Instructions Before Using Your Canister VaccumContents Assembling the vacuum OptionsON/OFF Switch Power CordOperating the vacuum Hose Power ControlRadio Frequency REMOTE-CONTROL BodyVacuuming with the Power Brush Power BrushOverload Protector Accessories Optional Using AccessoriesPipe Parquet Brush Optional Maintaining Floor ToolsVacuums dust in a wide area at once Throw the dust in the bin Emptying the Dust BINThen, lift the dust bin out Away Close the dust bin coverTo Confirm the Dust Pack Needs Cleaning Cleaning the Dust PackWhen to Clean the Dust Pack Turn the vacuum power to ‘MAX’ Body ControlCleaning the Dust Pack Do not reverse the +, poles Cleaning the Outlet FilterChanging the Battery Dispose of the batteries propertyProblem Solution TroubleshootingInstructions Page Aspirateur Merci d’avoir choisi un produit SamsungRenseignements Relatifs À LA Sécurité Symboles AVERTISSEMENT/ATTENTION UtilisésAutres Symboles Utilisés Instructions Relative À LA Fiche PolariséeConsignes DE Sécurité Importantes Assemblage DE L’ASPIRATEUR Entretien DES Accessoires ETTable des matières Utilisation DE L’ASPIRATEURAssemblage de l’aspirateur OptionCordon Dalimentation Utilisation de l’aspirateurBouton DE Mise SOUS/HORS Tension Tuyau Télécommande PAR Signaux RadioélectriquesRéglage DE LA Puissance Corps DE LaspirateurAspiration Avec LA Brosse Électrique Brosse ÉlectriqueProtecteur Contre LES Surcharges Tube Utilisation DaccessoiresAccessoires EN Option Retirez la brosse à épousseter pour utiliser le suceur platDébranchez l’aspirateur de la prise électrique Entretien DES Accessoires Pour PlanchersBrosse Pour Parquet EN Option Éliminez la poussière d’une large zone ’une seule foisAtteinte, videz-le En appuyant sur le bouton Réservoir Vidage DU Réservoir À PoussièreLorsque le réservoir à Videz la poussière dans la Refermez le couvercle duQuand Nettoyer LE Groupe Filtrant Commande sur lappareilNettoyage DU Groupe Filtrant Pour Vérifier SI LE Groupe Filtrant Doit Être NettoyéNettoyage DU Groupe Filtrant Remplacement DES Piles Nettoyage DU Filtre DE SortieProblème Solution DépannagePage Aspiradora Símbolos DE Cuidado Y Advertencia Utilizados Información sobre seguridadInformación Sobre Seguridad Otros Símbolos UtilizadosInstrucciones DE Seguridad Importantes LEA Todas LAS Instrucciones Antes DE Usar SU AspiradoraFuncionamiento DE LA ContenidoArmado DE LA Aspiradora AspiradoraArmado de la aspiradora OpcionalCable DE Alimentación Interruptor DE ENCENDIDO/APAGADOManguera Control DE PotenciaControl Remoto DE Frecuencia DE Radio CuerpoCómo Aspirar CON EL Cepillo Mecánico Cepillo MecánicoProtector Contra Sobrecarga Tubo USO DE AccesoriosAccesorios Opcionales Desenchufe la aspiradora del tomacorriente Mantenimiento DE Accesorios Para PisoCepillo Para Parqué Opcional Alfombras con ﬂ ecosDepósito de polvo Presionando el botón De polvo Vaciado DEL Depósito DE PolvoLa marca que indica que la Deseche el polvo delCuándo Limpiar EL Depósito Para Polvo Limpieza DEL Depósito Para PolvoSi en un piso plano el indicador de veriﬁ cación del Deje secar la esponja y el Limpieza DEL Depósito Para PolvoDel depósito para polvo De 12 horas En el depósito para polvoLimpieza DEL Filtro DE Salida Cambio DE PilasSolución de problemas Problema SoluciónCode No. DJ68-00597P REV0.1