Pelco EH8106L Legacy manual Installation, Camera and Lens

Page 5

Installation

CAMERA AND LENS

To install the camera and lens:

1.Remove the rear plate of the enclosure (refer to Figure 1):

a.Remove the center cap from the Schrader valve.

b.Press and hold the center stem of the Schrader valve to relieve internal enclosure pressure.

c.Remove the spiral retaining ring from the back of the enclosure. Use a screwdriver to pry the end of the spiral retaining ring from the retaining ring groove.

d.Pull the T-handle to remove the rear plate from the housing.

2.Slide the sled out of the enclosure.

3.Remove the desiccant bag from the camera sled. Do not discard the bag.

4.Mount the camera and lens onto the sled:

a.Extend the lens to the maximum length before positioning the camera and lens.

b.Position the camera and lens so they do not extend beyond the track.

c.Fasten the camera and lens to the sled; the fastener is not supplied. (The most common fastener is a 1/4-inch x 20 screw, depending on the the camera type.)

5.Connect the wiring for camera power, lens functions, and video (refer to Figure 2 on page 6).

6.Unwrap and install the desiccant bag inside the enclosure.

7.Reinstall the camera sled by sliding it back into the enclosure body. Secure the unit with the spiral retaining ring.

8.Pressurize the inside of the enclosure (refer to Pressurizing the Enclosure on page 7).

 

SCHRADER

 

RETAINING

VALVE

PRESSURE

SPRING

 

RELIEF VALVE

END

 

 

MATING CONNECTOR

SPIRAL

GROUND STUD

RETAINING

 

SPRING

 

T-HANDLE

Figure 1. Rear View

C1420M-I (6/09)

5

Image 5
Contents EH8106L Legacy Pressurized Enclosure Contents Risk of Electric Shock Do not Open Important Safety InstructionsDescription Parts ListAccessories Camera and Lens InstallationWiring Diagram Mounting Power ConnectionPressurizing the Enclosure Servicing DisassemblyRecharging and Reassembly Electrical SpecificationsEnvironmental Product Warranty and Return Information